首页> 外文OA文献 >Scalable fault management architecture for dynamic optical networks : an information-theoretic approach
【2h】

Scalable fault management architecture for dynamic optical networks : an information-theoretic approach

机译:用于动态光网络的可扩展故障管理体系结构:信息理论方法

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

All-optical switching, in place of electronic switching, of high data-rate lightpaths at intermediate nodes is one of the key enabling technologies for economically scalable future data networks. This replacement of electronic switching with optical switching at intermediate nodes, however, presents new challenges for fault detection and localization in reconfigurable all-optical networks. Presently, fault detection and localization techniques, as implemented in SONET/G.709 networks, rely on electronic processing of parity checks at intermediate nodes. If similar techniques are adapted to all-optical reconfigurable networks, optical signals need to be tapped out at intermediate nodes for parity checks. This additional electronic processing would break the all-optical transparency paradigm and thus significantly diminish the cost advantages of all-optical networks. In this thesis, we propose new fault-diagnosis approaches specifically tailored to all-optical networks, with an objective of keeping the diagnostic capital expenditure and the diagnostic operation effort low. Instead of the aforementioned passive monitoring paradigm based on parity checks, we propose a proactive lightpath probing paradigm: optical probing signals are sent along a set of lightpaths in the network, and network state (i.e., failure pattern) is then inferred from testing results of this set of end-to-end lightpath measurements. Moreover, we assume that a subset of network nodes (up to all the nodes) is equipped with diagnostic agents - including both transmitters/receivers for probe transmission/detection and software processes for probe management to perform fault detection and localization. The design objectives of this proposed proactive probing paradigm are two folded: i) to minimize the number of lightpath probes to keep the diagnostic operational effort low, and ii) to minimize the number of diagnostic hardware to keep the diagnostic capital expenditure low.
机译:中间节点处的高数据速率光路的全光交换(代替电子交换)是​​经济上可扩展的未来数据网络的关键启用技术之一。然而,用中间节点处的光交换来代替电子交换,对于可重构的全光网络中的故障检测和定位提出了新的挑战。目前,在SONET / G.709网络中实现的故障检测和定位技术依赖于中间节点奇偶校验检查的电子处理。如果类似的技术适用于全光可重配置网络,则需要在中间节点分接光信号以进行奇偶校验。这种额外的电子处理将打破全光透明性范式,从而大大降低全光网络的成本优势。在本文中,我们提出了一种专为全光网络量身定制的新的故障诊断方法,目的是保持诊断资本支出和诊断操作成本低。代替前面提到的基于奇偶校验的被动监视范式,我们提出了一种主动的光路探测范式:沿着网络中的一组光路发送光探测信号,然后从网络的测试结果中推断出网络状态(即故障模式)。这套端到端的光路测量。此外,我们假设网络节点的子集(最多所有节点)都配备了诊断代理-包括用于探针传输/检测的发送器/接收器以及用于探针管理以执行故障检测和定位的软件过程。该提议的主动探测范例的设计目标有两个折叠:i)最小化光路探针的数量以保持较低的诊断操作努力; ii)最小化诊断硬件的数量以保持较低的诊断资本支出。

著录项

  • 作者

    Wen Yonggang;

  • 作者单位
  • 年度 2008
  • 总页数
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号