首页> 外文OA文献 >X-48B Flight Test Progress Overview
【2h】

X-48B Flight Test Progress Overview

机译:X-48B飞行测试进度概述

摘要

The results of a series of 39 flight tests of the X-48B Low Speed Vehicle (LSV) performed at the NASA Dryden Flight Research Center from July 2007 through December 2008 are reported here. The goal of these tests is to evaluate the aerodynamic and controls and dynamics performance of the subscale LSV aircraft, eventually leading to the development of a control system for a full-scale vehicle. The X-48B LSV is an 8.5%-scale aircraft of a potential, full-scale Blended Wing Body (BWB) type aircraft and is flown remotely from a ground control station using a computerized flight control system located onboard the aircraft. The flight tests were the first two phases of a planned three-phase research program aimed at ascertaining the flying characteristics of this type of aircraft. The two test phases reported here are: 1) envelope expansion, during which the basic flying characteristics of the airplane were examined, and 2) parameter identification, stalls, and engine-out testing, during which further information on the aircraft performance was obtained and the airplane was tested to the limits of controlled flight. The third phase, departure limiter assaults, has yet to be performed. Flight tests in two different wing leading edge configurations (slats extended and slats retracted) as well as three weight and three center of gravity positions were conducted during each phase. Data gathered in the test program included measured airplane performance parameters such as speed, acceleration, and control surface deflections along with qualitative flying evaluations obtained from pilot and crew observations. Flight tests performed to-date indicate the aircraft exhibits good handling qualities and performance, consistent with pre-flight simulations.
机译:这里报告了2007年7月至2008年12月在NASA德莱登飞行研究中心进行的X-48B低速飞行器(LSV)的39项飞行测试的一系列结果。这些测试的目的是评估超小型LSV飞机的空气动力学以及控制和动力学性能,最终导致全尺寸车辆控制系统的开发。 X-48B LSV是可能的全比例混合翼飞机(BWB)型飞机的8.5%比例飞机,可使用飞机上的计算机化飞行控制系统从地面控制站远程进行飞行。飞行测试是计划中的三个阶段研究计划的前两个阶段,旨在确定此类飞机的飞行特性。此处报告的两个测试阶段是:1)包络线扩张,在此期间检查飞机的基本飞行特性,以及2)参数识别,失速和发动机熄火测试,在此期间获得有关飞机性能的更多信息,以及飞机经过了测试,达到了受控飞行的极限。第三阶段,出发限制突击,尚未执行。在每个阶段中,进行了两种不同的机翼前缘构造(板条伸展而板条缩回)以及三个重物和三个重心位置的飞行测试。测试程序中收集的数据包括测量的飞机性能参数(例如速度,加速度和控制面偏转)以及从飞行员和机组人员的观察中获得的定性飞行评估。迄今为止进行的飞行测试表明飞机具有良好的操纵品质和性能,与飞行前模拟一致。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号