首页> 外文OA文献 >Co-production of hydrogen and carbon nanofibers from methane decomposition over zeolite Y supported Ni catalysts
【2h】

Co-production of hydrogen and carbon nanofibers from methane decomposition over zeolite Y supported Ni catalysts

机译:在沸石Y负载的Ni催化剂上甲烷分解产生的氢和碳纳米纤维联产

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

The objective of this paper is to study the influences of different operating conditions on the hydrogen formation and properties of accumulated carbon from methane decomposition using zeolite Y supported 15 and 30 Ni, respectively, at a temperature range between 500 and 650 degrees C in a pilot scale fixed bed reactor. The temperature ramp was showed a significant impact on the thermo-catalytic decomposition (TCD) of methane. An optimum temperature range of 550-600 degrees C were required to attain the maximum amount of methane conversion and revealed that at 550 and 600 degrees C, catalyst showed longer activity for the whole studied of experimental runs. Additionally, at 550 degrees C, the methane decomposition is two times longer for 30 Ni/Y zeolite than that for 15 Ni/Y zeolite catalyst, whereas it is almost three times higher at 500 degrees C. A maximum carbon yield of 614.25 and 157.54 g(c)/g(Ni) were reported after end of the complete reaction at 600 degrees C with 30 and 15 Ni/Y zeolite catalyst, respectively. From BET, TPD, and XRD analysis, we had reported that how the chemistry between the TCD of methane and metal content of the catalysts could significantly affect the hydrogen production as well as carbon nano-fibers. TEM analysis ensured that the produced carbon had fishbone type structures with a hollow core and grew from crystallites of Ni anchored on the external surface of the catalysts and irrespective of the metal loadings, the whisker types of nano filaments were formed as confirmed from FESEM analysis. Nevertheless, the effect of volume hourly space velocity (VHSV) on the methane conversion was also investigated and reported that the methane conversion increased as VHSV and nickel concentration in Ni-Y catalysts increased. Additionally, the initial methane decomposition rate increases with VHSV and it has reverse and non-linear relevancy to the weight of Ni/Y zeolite catalyst. (C) 2014 Elsevier Ltd. All rights reserved.
机译:本文的目的是研究分别在500和650摄氏度之间的温度范围内,分别使用15和30 Ni沸石Y承载的不同操作条件对氢形成和甲烷分解生成的积碳性质的影响,该沸石分别由15和30 Ni负载规模固定床反应器。温度上升表明对甲烷的热催化分解(TCD)有显着影响。为了达到最大的甲烷转化量,需要在550-600摄氏度的最佳温度范围内进行,并表明在550和600摄氏度下,催化剂在整个实验运行中显示出更长的活性。此外,在550摄氏度下,30 Ni / Y沸石的甲烷分解时间是15 Ni / Y沸石催化剂的甲烷分解时间的两倍,而在500摄氏度下甲烷分解的效率几乎高出三倍。最大碳产率为614.25和157.54在分别于30和15 Ni / Y沸石催化剂在600摄氏度下完成反应结束后,报告了g(c)/ g(Ni)。通过BET,TPD和XRD分析,我们已经报道了甲烷TCD与催化剂金属含量之间的化学反应如何显着影响制氢和碳纳米纤维。 TEM分析确保所产生的碳具有带空心核的鱼骨​​型结构,并且由锚定在催化剂外表面上的Ni的微晶生长而成,并且与金属负载无关,如FESEM分析所证实的,形成了晶须类型的纳米丝。然而,还研究了体积时空速(VHSV)对甲烷转化率的影响,并报道甲烷转化率随VHSV和Ni-Y催化剂中镍浓度的增加而增加。此外,甲烷的初始分解速率随VHSV的增加而增加,并且与Ni / Y沸石催化剂的重量呈反相关和非线性关系。 (C)2014 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号