Nichrome Burn Wire Release Mechanism for CubeSats.

摘要

The nichrome burn wire release mechanism uses a nichrome burn wire which when activated heats up and cuts through a Vectran tie down cable allowing the deployable on the satellite to actuate. The release mechanism was designed from scratch with the goals to make it small, inexpensive, simple, reliable and easy to use by anyone including student-run University CubeSat projects. The release mechanism, shown in Figure 1, utilizes a two saddle design with compression springs to apply a spring stroke and force to the nichrome wire to thermally cut through the Vectran cable when heated. Through a test program and using a design of experiments (DOE) approach it was determined that the applied current to the nichrome wire and the diameter of the nichrome wire were the key parameters governing successful performance. To activate the nichrome wire a constant current of 1.60 +/- 0.05 amps is applied to ensure a successful and reliable cut. The tight tolerance constant current source is necessary in order to reliably: (1) thermally cut the cable and (2) prevent overheating failure of the nichrome wire to allow the mechanism to be reusable for many actuations without replacing the nichrome filament. The tight tolerances on the current prevent failure of the nichrome wire from overheating under too much current in a vacuum while also providing adequate thermal margin to cut through the Vectran tie down cable in air which requires more current than in vacuum. The burn wire release mechanism has been tested in air at room temperature and in vacuum at temperatures as low as -50 C and as high as 70 C on two different Vectran cable thicknesses. The release mechanism has shown to have cut times ranging from 2.4 to 7.2 seconds under these operating conditions. The burn wire release mechanism has 400 firings in component and system level testing without a single failure. The mechanism has been qualified for flight on the TEPCE (Tether Electrodynamic Propulsion CubeSat Experiment) program to release two carpenter tape deployments and a stacer and tether deployment system.