首页> 外文期刊>Physica status solidi, B. Basic research >Annealing temperature dependence of photovoltaic properties of solar cells containing Cu2SnS3 thin films produced by co-evaporation
【24h】

Annealing temperature dependence of photovoltaic properties of solar cells containing Cu2SnS3 thin films produced by co-evaporation

机译:通过共蒸发生产的包含Cu2SnS3薄膜的太阳能电池光伏性能的退火温度依赖性

获取原文
获取原文并翻译 | 示例
           

摘要

The ternary compound Cu2SnS3 (CTS) is composed of elements that are low in cost, non-toxic, and abundant in the Earth's crust. In addition, CTS is a p-type semiconductor with a high reported absorption coefficient of more than 10(4)cm(-1) and a band gap energy of 0.92-1.77eV. It is, therefore, considered to be a suitable candidate for the absorber layer in thin film solar cells. In the present study, CTS thin films were produced by first depositing precursor films by co-evaporation of Cu, Sn, and S, and then annealing them. Solar cells were then fabricated using the CTS films as absorber layers, and the dependence of their photovoltaic properties on the annealing temperature was investigated. The solar cell using the CTS thin film annealed at 570 degrees C exhibited an open-circuit voltage of 248mV, a short-circuit current density of 33.5mA/cm(2), a fill factor of 0.439, and a conversion efficiency of 3.66%. (C) 2015 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim
机译:三元化合物Cu2SnS3(CTS)由低成本,无毒且在地壳中含量丰富的元素组成。此外,CTS是一种p型半导体,据报道其吸收系数超过10(4)cm(-1),带隙能量为0.92-1.77eV。因此,它被认为是薄膜太阳能电池中吸收层的合适候选者。在本研究中,首先通过共同蒸发Cu,Sn和S沉积前体薄膜,然后对其进行退火,从而生产出CTS薄膜。然后使用CTS薄膜作为吸收层来制造太阳能电池,并研究其光伏性能对退火温度的依赖性。使用在570摄氏度下退火的CTS薄膜的太阳能电池表现出248mV的开路电压,33.5mA / cm(2)的短路电流密度,0.439的填充系数和3.66%的转换效率。 (C)2015 WILEY-VCH Verlag GmbH&Co.KGaA,Weinheim

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号