Determination of cobalt in biological samples by line-source and high-resolution continuum source graphite furnace atomic absorption spectrometry using solid sampling or alkaline treatment

摘要

Two procedures for the determination of Co in biological samples by graphite furnace atomic absorption spectrometry (GF AAS) were compared:solid sampling (SS) and alkaline treatment with tetramethylammonium hydroxide (TMAH) using two different instruments for the investigation:a conventional line-source (LS) atomic absorption spectrometer and a prototype high-resolution continuum source atomic absorption spectrometer.For the direct introduction of the solid samples,certified reference materials (CRM) were ground to a particle size <=50 mum.Alkaline treatment was carried out by placing about 250 mg of the sample in polypropylene flasks,adding 2 mL of 25% m/v tetramethylammonium hydroxide and de-ionized water.Due to its unique capacity of providing a 3-D spectral plot,a high-resolution continuum source (HR-CS) graphite furnace atomic absorption spectrometry was used as a tool to evaluate potential spectral interferences,including background absorption for both sample introduction procedures,revealing that a continuous background preceded the atomic signal for pyrolysis temperatures lower than 700 deg C.Molecular absorption bands with pronounced rotational fine structure appeared for atomization temperatures >1800 deg C probably as a consequence of the formation of PO.After optimization had been carried out using high resolution continuum source atomic absorption spectrometry,the optimized conditions were adopted also for line-source atomic absorption spectrometry.Six biological certified reference materials were analyzed,with calibration against aqueous standards,resulting in agreement with the certified values (according to the t-test for a 95% confidence level) and in detection limits as low as 5 ng g-~(-1).