...
首页> 外文期刊>Radiation measurements >Experimental study on the aging process of the LR 115 cellulose nitrate radon detector
【24h】

Experimental study on the aging process of the LR 115 cellulose nitrate radon detector

机译:LR 115硝酸纤维素ra探测器老化过程的实验研究

获取原文
获取原文并翻译 | 示例

摘要

An experimental determination of the aging process of cellulose nitrate detector material was based on the examination of special properties of the LR 115 solid state nuclear track detectors (SSNTDs) of various ages up to 18 years. The examined relevant parameters are the bulk etching rate upsilon (b) and the track etching rate upsilon (t). These parameters are responsible for the appearance, the size and the registration efficiency of tracks of alpha -particles from radon gas in the detector. To find a correlation between these material parameters and the detector sensitivity an experimental calibration of indoor room and outdoor soil detector devices based on LR 115 took place at the Umweltforschungszentrum Leipzig-Halle (Germany). To avoid routine calibration work in external radon exposure facilities a correction of the age dependent calibration factors with the material parameters measured in one's own laboratory was targeted. In this study a general age dependence, however, was not found. The following statements for practical applications can be made. (i) the bulk etching rate upsilon (b) for detectors of the same batch has a depth dependence and this dependence is constant over 2 years (LR 115 September 1994). (ii) detectors of different batches older than 5 years and stored at room temperature show an odd upsilon (b) behaviour when upsilon (b) is used for describing track shapes. (iii) the calibration factor of detectors of different batches that were stored at about +4 degreesC is constant over 5 years (LR 115 September 1994 and February 1999, Table 2). The conclusion is that LR 115 detectors not older than 5 years and stored in a refrigerator at about +4 degreesC should be preferred for radon measurements. Furthermore these detectors should be recalibrated every year and the microscope work of this calibrations should be performed by the same person who performs the measurements. In addition, a phenomenon related to fundamental track formation mechanisms was found, that the time straggling of the time t(through) when vertical tracks penetrate the 12 mum thick detector layer is independent of the age of the detectors and the energy of the alpha -particle at the detector surface. (C) 2001 Elsevier Science Ltd. All rights reserved. [References: 8]
机译:硝酸纤维素检测器材料老化过程的实验确定是基于对LR 115固态核径迹检测器(SSNTD)的特殊性能进行检查的,这些检测器的使用期限长达18年。检查的相关参数是整体蚀刻速率上硅(b)和轨迹蚀刻速率上硅(t)。这些参数负责检测器中来自ra气的α粒子的痕迹的外观,大小和配准效率。为了找到这些材料参数和检测器灵敏度之间的相关性,在德国莱比锡哈勒姆市政厅(Umweltforschungszentrum Leipzig-Halle)进行了基于LR 115的室内和室外土壤检测器设备的实验校准。为了避免在外部ra暴露设施中进行常规校准工作,目标是使用在自己的实验室中测量的材料参数校正与年龄相关的校准因子。在这项研究中,但是,没有发现一般的年龄依赖性。可以针对实际应用做出以下陈述。 (i)同一批次的探测器的整体蚀刻速率上升硅(b)具有深度依赖性,并且这种依赖性在2年内是恒定的(LR 115,1994年9月)。 (ii)当使用upsilon(b)来描述轨道形状时,在室温下存放的5年以上不同批次的检测器显示出奇怪的upsilon(b)行为。 (iii)在大约+4摄氏度下存储的不同批次的检测器的校准因子在5年中保持不变(LR 115 1994年9月和1999年2月,表2)。结论是,对于ra测量,应首选不超过5年且存储在约+4摄氏度的冰箱中的LR 115检测器。此外,这些检测器应每年重新校准,并且该校准的显微镜工作应由执行测量的同一个人执行。此外,发现了与基本磁道形成机制有关的现象,即垂直磁道穿透12微米厚的探测器层时,时间t(穿过)的时间散乱与探测器的寿命和α-的能量无关。探测器表面的颗粒。 (C)2001 Elsevier ScienceLtd。保留所有权利。 [参考:8]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号