首页> 外文期刊>Molecules >Influence of Post-Treatment Operations on Structural Properties and Photocatalytic Activity of Octahedral Anatase Titania Particles Prepared by an Ultrasonication-Hydrothermal Reaction
【24h】

Influence of Post-Treatment Operations on Structural Properties and Photocatalytic Activity of Octahedral Anatase Titania Particles Prepared by an Ultrasonication-Hydrothermal Reaction

机译:后处理操作对超声-水热反应制备的八面体锐钛型二氧化钛颗粒结构性质和光催化活性的影响

获取原文
获取原文并翻译 | 示例
           

摘要

The influence of changes in structural and physical properties on the photocatalytic activity of octahedral anatase particles (OAPs), exposing eight equivalent {101} facets, caused by calcination (2 h) in air or grinding (1 h) in an agate mortar was studied with samples prepared by ultrasonication (US; 1 h)-hydrothermal reaction (HT; 24 h, 433 K). Calcination in air at temperatures up to 1173 K induced particle shape changes, evaluated by aspect ratio (AR; d(001)/d(101) = depth vertical to anatase {001} and {101} facets estimated by the Scherrer equation with data obtained from X-ray diffraction (XRD) patterns) and content of OAP and semi-OAP particles, without transformation into rutile. AR and OAP content, as well as specific surface area (SSA), were almost unchanged by calcination at temperatures up to 673 K and were then decreased by elevating the calcination temperature, suggesting that calcination at a higher temperature caused dull-edging and particle sintering, the latter also being supported by the analysis of particle size using XRD patterns and scanning electron microscopic (SEM) images. Time-resolved microwave conductivity (TRMC) showed that the maximum signal intensity (I-max), corresponding to a product of charge-carrier density and mobility, and signal-decay rate, presumably corresponding to reactivity of charge carriers, were increased with increase in AR, suggesting higher photocatalytic activity of OAPs than that of dull-edged particles. Grinding also decreased the AR, indicating the formation of dull-edged particles. The original non-treated samples showed activities in the oxidative decomposition of acetic acid (CO2 system) and dehydrogenation of methanol (H-2 system) comparable to and lower than those of a commercial anatase titania (Showa Denko Ceramics FP-6), respectively. The activities of calcined and ground samples for the CO2 system and H-2 system showed almost linear relations with AR and I-max, respectively, suggesting that those activities may depend on different properties.
机译:研究了结构和物理性质变化对八面体锐钛矿颗粒(OAPs)的光催化活性的影响,该八面体锐钛矿颗粒暴露了八个等效的{101}面,这是由在空气中煅烧(2 h)或在玛瑙研钵中研磨(1 h)引起的样品通过超声(US; 1 h)-水热反应(HT; 24 h,433 K)制备。空气中的煅烧温度高达1173 K,引起的颗粒形状发生变化,由纵横比(AR; d(001)/ d(101)=垂直于锐钛矿{001}和{101}刻面的深度,通过Scherrer方程使用数据估算)由X射线衍射(XRD)图获得)和OAP和半OAP颗粒的含量,而不会转变成金红石。 AR和OAP含量以及比表面积(SSA)在最高673 K的温度下经煅烧几乎没有变化,但随后通过升高煅烧温度而降低,这表明在较高的温度下煅烧会导致钝化和颗粒烧结使用XRD图案和扫描电子显微镜(SEM)图像进行粒度分析也为后者提供了支持。时间分辨的微波电导率(TRMC)表明,最大信号强度(I-max)与电荷载流子密度和迁移率的乘积相对应,而信号衰减率则与电荷载流子的反应性相对应,随增加而增加在AR中,表明OAPs的光催化活性高于钝边颗粒。研磨还降低了AR,表明形成了暗淡的颗粒。原始未经处理的样品分别具有与商业锐钛型二氧化钛(昭和电工陶瓷FP-6)相当的性能,并低于乙酸的氧化分解(CO2系统)和甲醇的脱氢(H-2系统)活性。 。 CO2系统和H-2系统的煅烧和研磨样品的活度分别与AR和I-max呈线性关系,表明这些活度可能取决于不同的性质。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号