...
首页> 外文期刊>Multibody system dynamics >Dynamics of a three-module vibration-driven system with non-symmetric Coulomb's dry friction
【24h】

Dynamics of a three-module vibration-driven system with non-symmetric Coulomb's dry friction

机译:具有非对称库仑干摩擦的三模块振动驱动系统的动力学

获取原文
获取原文并翻译 | 示例
           

摘要

In the present paper, a three-module vibration-driven system moving on a rough horizontal plane is modeled to investigate the relation among the system's steady-state motion, external Coulomb's dry friction force and internal excitations. Each module of the system represents a vibration-driven system composed of a rigid body and a movable internal mass. Major attention is focused on the primary resonance situation that the excitation frequency is close to the first-order natural frequency of the system. In the case that the external friction is low, the internal excitation is weak and the stick-slip motion is negligible, both methods of averaging and modal superposition are employed to study the steady-state motion of the system. Through a set of algebraic equations, an approximate value of the system's average steady-state velocity is obtained. Several numerical examples are calculated to verify the validity of the analytical results both qualitatively and quantitatively. It is seen that big quantitative errors will appear if stick-slip motions occur. Then, two mechanisms for the possible stick-slip motions are put forward, which explain the errors on the average steady-state velocity. Numerical simulations verify our analysis on the stick-slip effects and their mechanisms. Finally, to maximize the average steady-state velocity of the system, optimal control problem is studied. It is shown that, in addition to modifying the friction coefficients, the improvement of the system's efficiency can be provided by changing the initial phase shifts among the three internal excitations.
机译:在本文中,对在粗糙水平面上移动的三模块振动驱动系统进行建模,以研究系统的稳态运动,外部库仑干摩擦力和内部激励之间的关系。系统的每个模块代表一个由刚性主体和可移动内部质量组成的振动驱动系统。主要注意力集中在励磁频率接近系统的一阶固有频率的主要共振情况上。在外部摩擦较小,内部激励较弱且粘滑运动可忽略不计的情况下,均值和模态叠加方法均用于研究系统的稳态运动。通过一组代数方程,可以获得系统平均稳态速度的近似值。计算了几个数值示例,以定性和定量地验证分析结果的有效性。可以看出,如果发生粘滑运动,将会出现很大的定量误差。然后,提出了两种可能的粘滑运动机制,解释了平均稳态速度的误差。数值模拟验证了我们对粘滑效应及其机理的分析。最后,为了最大化系统的平均稳态速度,研究了最优控制问题。结果表明,除了修改摩擦系数之外,还可以通过更改三个内部激励之间的初始相移来提高系统效率。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号