首页> 外文期刊>Medical Physics >Beam collimation with polycapillary x-ray optics for high contrast high resolution monochromatic imaging.
【24h】

Beam collimation with polycapillary x-ray optics for high contrast high resolution monochromatic imaging.

机译:光束准直与多毛细管X射线光学器件实现高对比度,高分辨率的单色成像。

获取原文
获取原文并翻译 | 示例
           

摘要

Monochromatic imaging can provide better contrast and resolution than conventional broadband radiography. In broadband systems, low energy photons do not contribute to the image, but are merely absorbed, while high energy photons produce scattering that degrades the image. By tuning to the optimal energy, one can eliminate undesirable lower and higher energies. Monochromatization is achieved by diffraction from a single crystal. A crystal oriented to diffract at a particular energy, in this case the characteristic line energy, diffracts only those photons within a narrow range of angles. The resultant beam from a divergent source is nearly parallel, but not very intense. To increase the intensity, collimation was performed with polycapillary x-ray optics, which can collect radiation from a divergent source and redirect it into a quasi parallel beam. Contrast and resolution measurements were performed with diffracting crystals with both high and low angular acceptance. Testing was first done at 8 keV with an intense copper rotating anode x-ray source, then 17.5 keV measurements were made with a low power molybdenum source. At 8 keV, subject contrast was a factor of five higher than for the polychromatic case. At 17.5 keV, monochromatic contrast was two times greater than the conventional polychromatic contrast. The subject contrasts measured at both energies were in good agreement with theory. An additional factor of two increase in contrast, for a total gain of four, is expected at 17.5 keV from the removal of scatter. Scatter might be simply removed using an air gap, which does not degrade resolution with a parallel beam.
机译:单色成像可以提供比常规宽带射线照相更好的对比度和分辨率。在宽带系统中,低能光子不会对图像有所贡献,而只是被吸收,而高能光子会产生散射,从而降低图像质量。通过调整到最佳能量,可以消除不必要的较低和较高能量。单色化是通过单晶衍射实现的。定向为以特定能量(在此情况下为特征线能量)衍射的晶体仅衍射那些在窄角度范围内的光子。来自发散源的合成光束几乎是平行的,但不是很强。为了增加强度,使用多毛细管X射线光学仪进行了准直,该光学仪可以收集来自发散源的辐射并将其重定向到准平行光束中。对比度和分辨率的测量是使用具有高角度接受度和低角度接受度的衍射晶体进行的。首先使用强铜旋转阳极X射线源在8 keV下进行测试,然后使用低功率钼源进行17.5 keV测量。在8 keV时,对象对比度比多色情况高5倍。在17.5 keV时,单色对比度是传统多色对比度的两倍。在两种能量下测得的主题对比与理论非常吻合。相比之下,由于消除了散射,在总增益为4的情况下,总的增益为4时,预期会增加2倍。可以使用气隙简单地消除散射,这不会降低平行光束的分辨率。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号