Forces and ionic transport between mica surfaces: Implications for pressure solution

摘要

Using a surface forces apparatus (SFA), we have studied the interactions between mica surfaces in pure and mixed NaCl and CaCl2 solutions at relevant geological conditions of pressure and electrolyte composition. Our results show that the short-range (0-50 Angstrom) colloidal forces, including attractive van der Waals and ion-correlation forces, repulsive electrostatic forces, and oscillatory or monotonically repulsive hydration (surface-induced water structure-dependent) forces are involved in different stages of pressure solution. These forces depend on the type (Na+, Ca2+, and H+) and concentration (6-600 mM) of the cations present in the solution. Equilibrium water film thicknesses were measured as a function of the applied (normal) pressure up to 50 MPa (500 atm) and ranged from 30 to 0 Angstrom at pressures above 10 MPa (100 atm). Measurements were also made of the rates of diffusion and exchange of ions into and out of such ultrathin films, and on the nucleation and growth of ionic crystallites on and between the surfaces, which occurred only in the presence of calcium ions. Diffusion of ions into and out of structured water films as thin as one to five water molecules (3 to 15 Angstrom) were found to be surprisingly rapid and never less than two orders of magnitude below the diffusion in bulk water. In contrast, the rates of binding and exchange of ions to the surfaces were found to be the rate-limiting steps to adsorption and crystal formation. These findings imply that, for certain systems or conditions, pressure solution rates could be limited by surface reactions rather than by ion diffusion in thin fluid films. Copyright (C) 2003 Elsevier Science Ltd. [References: 68]