首页> 外文期刊>European journal of cardio-thoracic surgery: Official journal of the European Association for Cardio-thoracic Surgery >Assessment of coronary sinus anatomy between normal and insufficient mitral valves by multi-slice computertomography for mitral annuloplasty device implantation.
【24h】

Assessment of coronary sinus anatomy between normal and insufficient mitral valves by multi-slice computertomography for mitral annuloplasty device implantation.

机译:通过多层计算机断层摄影术评估二尖瓣正常和不足的二尖瓣之间的冠状窦解剖结构。

获取原文
获取原文并翻译 | 示例
           

摘要

Introduction: Latest techniques enable positioning of devices into the coronary sinus (CS) for mitral valve (MV) annuloplasty. We evaluate the feasibility of non-invasive assessment to determine CS anatomy and its relation to MV annulus and coronary arteries by multi-slice CT (MSCT) in normal and insufficient MV. Methods: Fifty patients (33 males, 17 females, age 67+/-11 years) were studied retrospectively by 64-MSCT scans for anatomical criteria regarding CS and its relation to MV annulus and circumflex artery (CX). We included 24 patients with severe mitral insufficiency and 26 with no MV disease. Diameter of MV, of proximal and distal ostium of CS, length and volume of CS, angle between anterior interventricular vein (AIV) and CS, caliber change of CX before, under/over and after CS were analysed. Different anatomical correlations were demonstrated: distance of MV annulus to CS, CX to CS. Results: Diameter of proximal CS ostium was significantly larger in insufficient MV compared to normal MV (11+/-2.8mm vs 9.9+/-2.5mm; p<0.024). CS was significantly longer in patients with insufficient MV (125.4+/-17mm vs 108.9+/-18mm; p<0.003) with also significant differences in volume of CS (p<0.039). Significant difference in annulus diameter, 46.1+/-6mm (insufficient MV) versus 39.5+/-7.5mm, p<0.004 was observed. Angle CS-AIV was 103.5+/-29 degrees (range 52 degrees -144 degrees ) in insufficient valves versus 118.2+/-24.5 degrees (range 73 degrees -166 degrees ) in normal valves with a tendency to higher angles in normal valves (p=0.06). Distance of MV annulus to CS measured 16+/-4.1/14.2+/-3.6mm (insufficientormal MV) without significant difference between groups. In 15 patients CX ran under CS. Eighty-four percent of these patients (13/15) show a decrease in CS caliber in the area of intersection. In 14 patients CS ran over and in one patient the diameter of the CS at intersecting region was smaller. In 16 patients no direct point of contact was visible, in five patients CX to CS positioning was not evaluable. Conclusion: There is a significant anatomic difference between normal and insufficient MV, which might be the basis for any interventional approaches through the CS. Exact measurements of all structures and its anatomic correlations are possible with MSCT, which allows pre-interventional planning.
机译:简介:最新技术可将设备定位到二尖瓣(MV)瓣环成形术的冠状窦(CS)中。我们评估在正常和不足的MV中通过多层CT(MSCT)确定CS解剖结构及其与MV环和冠状动脉的关系的非侵入性评估的可行性。方法:通过64-MSCT扫描回顾性研究了50例患者(男33例,女17例,年龄67 +/- 11岁),以了解有关CS及其与MV环和回旋支(CX)的关系的解剖学标准。我们纳入了24例严重的二尖瓣关闭不全患者和26例无MV疾病的患者。分析了MV的直径,CS的近端和远端口,CS的长度和体积,前室静脉(AIV)和CS之间的角度,CS前后,前后的CX口径变化。证明了不同的解剖相关性:MV环到CS的距离,CX到CS的距离。结果:与正常MV相比,MV不足时近端CS口的直径明显更大(11 +/- 2.8mm vs 9.9 +/- 2.5mm; p <0.024)。 MV不足患者的CS显着更长(125.4 +/- 17mm对108.9 +/- 18mm; p <0.003),CS量也有显着差异(p <0.039)。观察到环直径的显着差异,即46.1 +/- 6mm(MV不足)与39.5 +/- 7.5mm,p <0.004。正常阀门中的角度CS-AIV为103.5 +/- 29度(范围52度-144度),而普通阀门中的角度CS-AIV为118.2 +/- 24.5度(范围73度-166度),而正常阀门中的角度倾向于增加( p = 0.06)。 MV环到CS的距离为16 +/- 4.1 / 14.2 +/- 3.6mm(MV不足/正常),两组之间无显着差异。在15例患者中,CX接受了CS治疗。这些患者中有84%(13/15)在交叉区域的CS口径降低。在14例患者中,CS翻倒,而在一名患者中,相交区域的CS直径较小。在16位患者中,没有直接的接触点可见,在5位患者中,从CX到CS的位置无法评估。结论:正常MV和不足MV之间存在明显的解剖学差异,这可能是通过CS进行任何介入方法的基础。使用MSCT可以对所有结构及其解剖相关性进行精确测量,从而可以进行介入前计划。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号