首页> 外文期刊>Boundary-layer Meteorology >Roughness Effects on Wind-Turbine Wake Dynamics in a Boundary-Layer Wind Tunnel
【24h】

Roughness Effects on Wind-Turbine Wake Dynamics in a Boundary-Layer Wind Tunnel

机译:粗糙度对边界层风洞中风轮机尾流动力学的影响

获取原文
获取原文并翻译 | 示例
       

摘要

Increasing demand in wind energy has resulted in increasingly clustered wind farms, and raised the interest in wake research dramatically in the last couple of years. To this end, the present work employs an experimental approach with scaled three-bladed wind-turbine models in a large boundary-layer wind-tunnel. Time-resolved measurements are carried out with a three-component hot-wire anemometer in the mid-vertical plane of the wake up to a downstream distance of eleven turbine diameters. The major issue addressed is the wake dynamics i.e. the flow and turbulence characteristics as well as spectral content under two different neutral boundary-layer inflow conditions. The wind tunnel is arranged with and without roughened surfaces in order to mimic moderately rough and smooth conditions. The inflow characterization is carried out by using all three velocity components, while the rest of the study is focused on the streamwise component's evolution. The results show an earlier wake recovery, i.e. the velocity deficit due to the turbine is less persistent for the rough case due to higher incoming turbulence levels. This paves the way for enhanced mixing from higher momentum regions of the boundary layer towards the centre of the wake. The investigation on the turbulent shear stresses is in line with this observation as well. Moreover, common as well as distinguishing features of the turbulent-scales evolution are detected for rough and smooth inflow boundary-layer conditions. Wake meandering disappears for rough inflow conditions but persists for smooth case with a Strouhal number similar to that of a solid disk wake.
机译:对风能的需求不断增长,导致风力发电场日益聚集,并在过去几年中极大地提高了对尾流研究的兴趣。为此,本工作采用了在大型边界层风洞中采用比例缩放的三叶风力涡轮机模型的实验方法。时间分辨的测量是在尾流的垂直中平面使用三分量热线风速计进行的,直至下游的11个涡轮机直径。解决的主要问题是尾流动力学,即在两种不同的中性边界层入流条件下的流动和湍流特性以及光谱含量。风洞的布置带有或不带有粗糙的表面,以模拟中等程度的粗糙和光滑状况。流入特征是通过使用所有三个速度分量进行的,而其余的研究则集中在沿流分量的演变上。结果显示出较早的尾流恢复,即,由于较高的进入湍流水平,在粗糙情况下由于涡轮机引起的速度不足持续性较小。这为从边界层的较高动量区域向尾流中心增强混合铺平了道路。湍流剪应力的研究也与此观察相符。此外,对于粗糙和光滑的流入边界层条件,可检测到湍流尺度演变的共同特征和区别特征。在粗糙的入水条件下,尾流曲折消失,但在平稳情况下持续存在,斯托鲁赫数类似于固态盘尾波。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号