An influence of active additives on the formation of selected indicators of the condition of the X10CrNi18-8 stainless steel surface layer in MQCL conditions

摘要

The paper presents the results of the research into the impact of anti-wear added to emulsion mist on the geometrical state of the machined surface of stainless steel after turning. In the research, the following machining conditions were compared: dry machining and cooling with compressed air, emulsion mist, emulsion mist + Crodafos O4A-LQ-(MH) and emulsion mist + Crodafos EHA-LQ-(MH). In the first stage, the influence of modifiers on roughness parameters of the machined surface were established. The aim of the second stage was to submit the machined material to microroentgenospectral analysis. The presence of chemical elements on the machined material surface for the aforementioned conditions of machining was analysed. Research results indicate that the application of cooling with emulsion mist with modifiers reduces the roughness parameters of the machined material even up to 80%. Adequately selected conditions of forming emulsion mist forms border layer, beneficially influencing the cutting conditions.