首页> 外文期刊>Applied Geochemistry: Journal of the International Association of Geochemistry and Cosmochemistry >In situ AFM study on barite (001) surface dissolution in NaCl solutions at 30 ℃
【24h】

In situ AFM study on barite (001) surface dissolution in NaCl solutions at 30 ℃

机译:30℃NaCl溶液中重晶石(001)表面溶解的原位原子力显微镜研究

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

This paper reports in situ observations on barite (001) surface dissolution behavior in 0.1-0.001 M NaCl solutions at 30 ℃ using atomic force microscopy (AFM). The step retreating on barite (001) surfaces changed with increasing NaCl solution concentrations. In solutions with a higher NaCl concentration(P0.01 M), many steps showed curved or irregular fronts during the later experimental stage, while almost all steps in solutions with a lower NaCl concentration exhibited straight or angular fronts, even during the late stage. The splitting phenomenon of the initial hhk0i one-layer steps (7.2 ?) into two half-layer steps (3.6 ?) occurred in all NaCl solutions, while that of the initial [010] one-layer steps observed only in the 0.1 M NaCl solution. The step retreat rates increased with an increasing NaCl solution concentration. We observed triangular etch pit and deep etch pit formation in all NaCl solutions, which tended to form late in solutions with lower NaCl concentrations. The deep etch pit morphology changed with increasing NaCl solution concentrations. A hexagonal form elongated in the [010] direction was bounded by the {100}, {310}, and (001) faces in a 0.001 M NaCl solution, and a rhombic form was bounded by the {510} and (001) faces in 0.01 M and 0.1 M NaCl solutions. An intermediate form was observed in a 0.005 M NaCl solution, which was defined by {100}, a curved face tangent to the [010] direction, {310}, and (001) faces: the intermediate form appeared between the hexagonal and rhombic forms in solutions with lower and higher NaCl concentrations, respectively. The triangular etch pit and deep etch pit growth rates also increased with the NaCl solution concentration. Combining the step and face retreat rates in NaCl solutions estimated in this AFM study as well as the data on the effect of water temperature on the retreat rates reported in our earlier study, we produced two new findings. One finding is that the retreat rates increase by approximately two-fold when the NaCl solution concentration increases by one order of magnitude, and the other finding is that the retreat rate increase due to a one order of magnitude increase in the NaCl concentration corresponds to an increase of approximately8 ℃ in water temperature. This correlation may help to understand and evaluate increasing dissolution kinetics induced by the different mechanisms where barite dissolution is promoted by the catalytic effect of Na~+ and Cl~- ions (through an increase in the NaCl solution concentration) or by an increase in the hydration of Ba(2+) and SO_4~(2-) (through an increase in water temperature).
机译:本文利用原子力显微镜(AFM)对30℃下0.1-0.001 M NaCl溶液中重晶石(001)的表面溶解行为进行了现场观察。重晶石(001)表面上的后退步骤随NaCl溶液浓度的增加而变化。在较高的NaCl浓度(P0.01 M)溶液中,许多步骤在后期实验阶段显示弯曲或不规则的前沿,而在较低NaCl浓度的溶液中,几乎所有步骤甚至在后期都表现出笔直或成角的前沿。在所有NaCl溶液中均发生了最初的hhk0i一级步骤(7.2?)分裂为两个半层步骤(3.6?)的现象,而仅在0.1 M NaCl中观察到了初始的[010]一级步骤的分裂现象。解。随着NaCl溶液浓度的增加,步退速率增加。我们在所有NaCl溶液中观察到三角形蚀刻坑和深蚀刻坑的形成,这些趋势倾向于在NaCl浓度较低的溶液中形成得较晚。深腐蚀坑的形貌随NaCl溶液浓度的增加而变化。在010 M NaCl溶液中,沿[010]方向伸长的六边形以{100},{310}和(001)面为边界,而菱形以{510}和(001)面为边界。在0.01 M和0.1 M NaCl溶液中溶解。在0.005 M NaCl溶液中观察到一种中间形式,该中间形式由{100}定义,该曲面与[010]方向,{310}和(001)面相切:该中间形式出现在六角形和菱形之间分别在较低和较高NaCl浓度的溶液中形成。三角形蚀刻坑和深蚀刻坑的生长速率也随NaCl溶液浓度的增加而增加。结合在该AFM研究中估计的NaCl溶液中的台阶和面部退缩速率,以及在我们较早的研究中报告的水温对退缩速率的影响数据,我们得出了两个新发现。一个发现是,当NaCl溶液浓度增加一个数量级时,退缩速率大约增加两倍;而另一个发现是,由于NaCl浓度增加一个数量级,退缩速率相应增加。水温升高约8℃。这种相关性可能有助于理解和评估由不同机理引起的溶解动力学的增加,其中Na〜+和Cl〜-离子的催化作用(通过增加NaCl溶液浓度)或通过增加NaCl和Cl_-的离子来促进重晶石溶解。 Ba(2+)和SO_4〜(2-)的水合(通过提高水温)。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号