...
首页> 外文期刊>Anesthesia and Analgesia: Journal of the International Anesthesia Research Society >Ventilation-perfusion ratio in perflubron during partial liquid ventilation.
【24h】

Ventilation-perfusion ratio in perflubron during partial liquid ventilation.

机译:部分液体通风期间全氟辛烷中的通气-灌注比。

获取原文
获取原文并翻译 | 示例

摘要

BACKGROUND: Functional magnetic resonance imaging (fMRI) of fluorine-19 allows for the mapping of oxygen partial pressure within perfluorocarbons in the alveolar space (Pao(2)). Theoretically, fMRI-detected Pao(2) can be combined with the Fick principle approach, i.e., a mass balance of oxygen uptake by ventilation and delivery by perfusion, to quantify the ventilation-perfusion ratio (Va/Q) of a lung region: The mixed venous blood and the inspiratory oxygen fraction, which are equal for all lung regions, are measured. In addition, the local expiratory oxygen fraction and the end capillary oxygen content, both of which may differ between the lung regions, are calculated using the fMRI-detected Pao(2). We investigated this approach by numerical simulations and applied it to quantify local Va/Q in the perfluorocarbons during partial liquid ventilation. METHODS: Numerical simulations were performed to analyze the sensitivity of the Va/Q calculation and to compare this approach with another one proposed by Rizi et al. in 2004 (Magn Reson Med 2004;52:65-72). Experimentally, the method was used during partial liquid ventilation in 7 anesthetized pigs. The Pao(2) distribution in intraalveolar perflubron was measured by fluorine-19 MRI. Respiratory gas fractions together with arterial and mixed venous blood samples were taken to quantify oxygen partial pressure and content. Using the Fick principle, the local Va/Q was estimated. The impact of gravity (nondependent versus dependent) of perflubron dose (10 vs 20 mL/kg body weight) and of inspired oxygen fraction (Fio(2)) (0.4-1.0) on Va/Q was examined. RESULTS: In numerical simulations, the Fick principle proved to be appropriate over the Va/Q range from 0.02 to 2.5. Va/Q values were in acceptable agreement with the method published by Rizi et al. In the experimental setting, low mean Va/Q values were found in perflubron (confidence interval [CI] 0.08-0.29 with 20 mL/kg perflubron). At this dose, Va/Q in the nondependent lung was higher (CI 0.18-0.39) than in the dependent lung regions (CI 0.06-0.16; P = 0.006; Student t test). Differences depending on Fio(2) or perflubron dose were, however, small. CONCLUSION: The results show that derivation of Va/Q from local Po(2) measurements using fMRI in perflubron is feasible. The low detected Va/Q suggests that oxygen transport into the perflubron-filled alveolar space is significantly restrained.
机译:背景:氟19的功能磁共振成像(fMRI)允许映射肺泡空间中全氟化碳中的氧分压(Pao(2))。从理论上讲,fMRI检测到的Pao(2)可以与Fick原理方法结合使用,即通过通气和通过灌注输送吸收氧气的质量平衡,以量化肺区域的通气灌注比(Va / Q):测量所有肺区域均相同的混合静脉血和吸氧分数。此外,使用fMRI检测到的Pao(2)可以计算出局部呼气中的氧气含量和末端毛细血管中的氧气含量,两者在肺区域之间可能会有所不同。我们通过数值模拟研究了这种方法,并将其应用于量化部分液体通风过程中全氟化碳中的局部Va / Q。方法:进行了数值模拟,以分析Va / Q计算的敏感性,并将这种方法与Rizi等人提出的另一种方法进行比较。在2004年(Magn Reson Med 2004; 52:65-72)。实验上,该方法用于7只麻醉猪的部分液体通风。 Pao(2)在肺泡内perflubron中的分布是通过氟19 MRI测量的。采集呼吸气体分数以及动脉和混合静脉血样本以量化氧气分压和含量。使用菲克原理,估计了当地的Va / Q。检查了全氟醚剂量(10 vs 20 mL / kg体重)的重力(非依赖性与依赖性)和吸氧分数(Fio(2))(0.4-1.0)对Va / Q的影响。结果:在数值模拟中,Fick原理在VA / Q范围从0.02到2.5的范围内被证明是合适的。 Va / Q值与Rizi等人发表的方法一致。在实验环境中,全氟苯氟醚的平均Va / Q值较低(20毫升/千克全氟溴铵的置信区间[CI] 0.08-0.29)。在此剂量下,非依赖性肺中的Va / Q值(CI 0.18-0.39)高于依赖性肺区域(CI 0.06-0.16; P = 0.006; Student t检验)。但是,取决于Fio(2)或全氟虫剂量的差异很小。结论:结果表明,在全氟仑中使用功能磁共振成像从局部Po(2)测量值推导Va / Q是可行的。较低的检测到的Va / Q值表明氧向充满全氟隆的肺泡腔中的迁移受到了明显的抑制。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号