Heat Flow and Solidification Modeling of Industrial Scale, Ingot Casting Operation

摘要

A model, based on the concept of effective thermal conductivity, was developed to study thermal fields and the resultant solidification behavior of large, round, industrial size ingots. In this, flow and turbulence phenomena during mold filling as well as subsequent solidification were not modeled explicitly but their influence was accounted for by artificially raising the thermal conductivity of solidifying steel. Thus, a conduction like equation embodying a conjugate approach was applied to simultaneously predict the evolution of temperature fields in the mold as well as in the solidifying ingot following teeming. Prior to comparing model predictions against industrial scale measurements, sensitivity of calculations to grid size, time step height, convergence criterion etc. were rigorously assessed. Similarly, modeling of interfacial resistance, chemical reactions and heat effects in the hot top as well as their influence on predicted results were evaluated computationally. Embodying mixed thermal boundary conditions (free convection + radiation) at the mold wall, temperature fields during solidification of two different industrial large ingots were predicted numerically. Parallely, mold wall temperature was monitored as a function of time and surface temperature of ingot was measured at the instant of mold stripping using hand held, radiation pyrometers. Incorporating relevant operating conditions (viz., mold dimensions and size, ingot and hot top dimensions and material, initial mold and liquid temperature etc.) into the calculation scheme, predictions were made via a computational procedure developed in-house and results thus obtained were compared against equivalent industrial scale measurements. Very reasonable agreement between the two was demonstrated.