...
【24h】

Observer-based nonlinear precise control of pneumatic servo systems

机译:基于观察者的气动伺服系统非线性精确控制

获取原文
获取原文并翻译 | 示例
           

摘要

Pneumatic systems are used in a wide range of industrial robotic and automation systems due to their interesting properties. However, air compressibility, friction, and the other nonlinear characteristics of a servo pneumatic system are difficulties, which contribute to use modern controllers. Conventional linear controllers face steady-state error and uncertainty. Nonlinear modeling with model-based control is a good choice to deal with this problem. In this paper, behavior equation of flow and pressure, friction, and other nonlinear factors are studied. Afterward to reach precise position tracking and low steady error, sliding mode control is proposed. In this way, measurement of pressures and other states of system is required. To reduce the cost of using pressure sensor, observation of pressure with nonlinear high gain observer is suggested. It was seen that the new proposed approach solved the observability problem of servo pneumatic systems. Pressure signal of each sides of cylinder are observed simultaneously by measurement of piston position. Finally, stability of designed controller is studied in the presence of observed states. Experimental results validate the advantage of using designed controller-observer instead of conventional proportional-integral-derivative controller with different input signals in the presence of high friction actuator.
机译:由于其有趣的特性,气动系统用于各种工业机器人和自动化系统。然而,空气压缩性,摩擦和伺服气动系统的其他非线性特性是困难的,这有助于使用现代控制器。传统的线性控制器面临稳态误差和不确定性。基于模型的控制的非线性建模是处理此问题的不错选择。在本文中,研究了流动和压力,摩擦和其他非线性因子的行为方程。之后要达到精确的位置跟踪和低稳定的误差,提出了滑模控制。以这种方式,需要测量压力和其他系统状态。为了降低使用压力传感器的成本,提出了具有非线性高增益观察者的压力的观察。有人看来,新的拟议方法解决了伺服气动系统的可观察性问题。通过测量活塞位置同时观察圆柱体的每侧的压力信号。最后,在观察状态存在下研究了设计控制器的稳定性。实验结果验证了使用设计控制器观察者的优点,而不是在高摩擦致动器存在下具有不同输入信号的传统比例整体衍生控制器。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号