首页> 外文期刊>Powder Technology: An International Journal on the Science and Technology of Wet and Dry Particulate Systems >Effect of bed particle size on heat transfer between fluidized bed of group b particles and vertical rifled tubes
【24h】

Effect of bed particle size on heat transfer between fluidized bed of group b particles and vertical rifled tubes

机译:床粒径对B组颗粒流化床和垂直膛管流化床传热的影响

获取原文
获取原文并翻译 | 示例
       

摘要

The effect of bed particle size on the local heat transfer coefficient between a fluidized bed and vertical rifled tubes (38 mm-O.D.) has been determined in a large-scale circulating fluidized bed (CFB) reactor. Bed particles with different Sauter mean particle diameter within the range of 0.219-0.411 mm and particle density in the range of 2650-2750 kg/m(3) were used as bed material in this heat transfer study. A gas fluidized bed furnace with 27.6 x 10.6 m cross-section above refractory line and 48 m in height was used. Air coal firing conditions at the membrane wall in the form of water tubes welded with lateral fins corresponded to a suspension density covering the range of 136-6.22 kg/m(3), furnace temperatures in the range of 1080-1164 K, a superficial gas velocity varied from 2.99 to 5.11 m/s and solids circulation flux covered a range of 23.3-26.2 kg/(m(2) s). For these operating conditions, the heat transfer analysis of CFB reactor with detailed analysis of bed-to-wall heat transfer coefficient along furnace height was investigated. In this work, the overall heat transfer coefficient was estimated using a mechanistic heat transfer model based on cluster renewal approach. The experimental results show that: (i) higher heat transfer coefficients along furnace height were found under finer bed particles size d(p) < 0.241 mm, (ii) heat transfer data confirms strong dependency of the overall heat transfer coefficient on suspension density and also hydrodynamic conditions within CFB furnace, (iii) for small bed particles, d(p) < 0.233 mm, the particle convection component plays dominant role in heat transfer mechanism, (iv) for large bed particles, d(p) > 0.366 mm, the effect of particle size on relative contribution of radiation from dispersed phase become essential with particle diameter increasing, and (v) for all bed particles with diameters in the range of 0.240-0.411 mm, the gas convection heat transfer coefficient between the fluidized bed (Geldart B particles) and the rifled tubes increased as the bed particles size increased. (C) 2016 Elsevier B.V. All rights reserved.
机译:在大规模循环流化床(CFB)反应器中,确定了床粒度对流化床和垂直膛管(38mm-O.D)之间的局部传热系数的影响。在0.219-0.411mm和颗粒密度范围内的床颗粒,在该传热研究中,使用了2650-2750kg / m(3)的颗粒密度。气体流化床炉,使用27.6×10.6米的横截面,使用48米高。膜壁的空气燃煤条件以横向翅片焊接的水管形式,悬浮密度覆盖136-6.22 kg / m(3)的范围,炉温范围为1080-1164 k,一种浅表气体速度从2.99变化到5.11 m / s,固体循环通量覆盖的范围为23.3-26.2 kg /(m(2))。对于这些操作条件,研究了CFB反应器的传热分析,并进行了沿炉高的床壁传热系数的详细分析。在这项工作中,使用基于集群更新方法的机械传热模型估计总传热系数。实验结果表明:(i)沿炉子高度的较高的传热系数在更细的床上颗粒d(p)<0.241mm,(ii)传热数据确认整体传热系数对悬浮密度的强依赖性以及CFB炉中的流体动力学条件,(III)对于小床颗粒,D(P)<0.233mm,粒子对流组分在传热机制中发挥显着作用,(iv)对于大床颗粒,D(P)> 0.366mm ,粒度对分散相的辐射相对贡献的影响变得与粒径增加的必需品,并且(v)对于直径的所有床颗粒,在0.240-0.411mm的范围内,流化床之间的气体对流传热系数。 (Geldart B颗粒)和膛线管随着床颗粒尺寸的增加而增加。 (c)2016年Elsevier B.v.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号