EFFECT OF Ar PRESSURE ON STRUCTURAL AND ELECTRICAL PROPERTIES OF Cu FILMS DEPOSITED ON GLASS BY DC MAGNETRON SPUTTERING

摘要

Cu films with thickness of 630-1300nm were deposited on glass substrates without heating by DC magnetron sputtering in pure Ar gas. Ar pressure was controlled to 0.5, 1.0 and 1.5Pa respectively. The target voltage was fixed at 500V but the target current increased from 200 to 1150mA with Ar pressure increasing. X-ray diffraction, scanning electron microscopy and atomic force microscopy were used to observe the structural characterization of the films. The resistivity of the films was measured using four-point probe technique. At all the Ar pressures, the Cu films have mixture crystalline orientations of [111], [200] and [220] in the direction of the film growth. The film deposited at lower pressure shows more [111] orientation while that deposited at higher pressure has more [220] orientation. The amount of larger grains in the film prepared at 0.5Pa Ar pressure is slightly less than that prepared at 1.0Pa and 1.5Pa Ar pressures. The resistivities of the films prepared at three different Ar pressures represent few differences, about 3-4 times of that of bulk material. Besides the deposition rate increases with Ar pressure because of the increase in target current. The contribution of the bombardment of energetic reflected Argon atoms to these phenomena is discussed.