...
首页> 外文期刊>Journal of Materials Science >Dynamics of dysprosium silicide nanostructures on Si(001) and (111) surfaces
【24h】

Dynamics of dysprosium silicide nanostructures on Si(001) and (111) surfaces

机译:Si(001)和(111)表面上硅化纳米结构的动力学

获取原文
获取原文并翻译 | 示例

摘要

The growth and coarsening dynamics of dysprosium silicide nanostructures are observed in real-time using photoelectron emission microscopy. The annealing of a thin Dy film to temperatures in the range of 700–1050 ℃ results in the formation of epitaxial rectangular silicide islands and nanowires on Si(001) and triangular and hexagonal silicide islands on Si(111). During continuous annealing, individual islands are observed to coarsen via Ostwald ripening at different rates as a consequence of local variations in the size and relative location of the surrounding islands on the surface. A subsequent deposition of Dy onto the Si(001) surface at 1050 ℃ leads to the growth of the preexisting islands and to the formation of silicide nanowires at temperatures above where nanowire growth typically occurs. Immediately after the deposition is terminated, the nanowires begin to decay from the ends, apparently transferring atoms to the more stable rectangular islands. On Si(111), a low continuous flux of Dy at 1050 ℃ leads to the growth of kinked and jagged island structures, which ultimately form into nearly equilateral triangular shapes.
机译:使用光电子发射显微镜实时观察到硅化纳米结构的生长和粗化动力学。 Dy薄膜的退火温度在700-1050℃范围内会导致在Si(001)上形成外延矩形硅化物岛和纳米线,在Si(111)上形成三角形和六边形硅化物岛。在连续退火过程中,由于表面上周围岛的大小和相对位置的局部变化,观察到各个岛通过奥斯特瓦尔德熟化以不同速率粗化。随后在1050℃下将Dy沉积到Si(001)表面上会导致先前存在的岛的生长,并在高于通常发生纳米线生长的温度下形成硅化物纳米线。沉积终止后,纳米线立即开始从末端衰减,显然将原子转移到更稳定的矩形岛上。在Si(111)上,Dy在1050℃处的连续通量低,会导致纽结和锯齿状岛状结构的生长,最终形成几乎等边的三角形。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号