...
首页> 外文期刊>Colloids and Surfaces, A. Physicochemical and Engineering Aspects >Marangoni instability of liquid-liquid systems with a surface-active solute
【24h】

Marangoni instability of liquid-liquid systems with a surface-active solute

机译:具有表面活性溶质的液-液体系的Marangoni不稳定性

获取原文
获取原文并翻译 | 示例

摘要

The onset of Marangoni instability in partially miscible liquid-liquid systems, such as organic-aqueous systems, in the presence of surface-active solutes is studied. The organic phase is initially pre-saturated with water and diffuses in the aqueous phase after both phases are contacted. The aqueous phase is contaminated with a surface-active solute which is also soluble in the organic phase and therefore, is transferred across the interface between the liquids. Marangoni instability in these systems may be induced by interfacial tension gradients, due to the heat of solution and the solute interfacial activity. In the present work, interfacial-tension-lowering solutes are considered. A linear stability analysis is carried out for both cases of stationary and oscillatory perturbations and the corresponding characteristic equations are derived in analytical form. They are analysed numerically for typical values of the physical parameters involved. It is shown that the stability conditions depend mainly on three physical parameters of the systems: the solute diffusivity ratio, the kinematic viscosity ratio and the product of the heat of solution and the thermal interfacial tension coefficient. In the stationary case, systems are stable when the solute diffusivity ratio is larger than one, independently of the magnitude of the viscosity ratio, and instability may appear if solute diffusivity is lower in the aqueous phase than in the organic phase. In the oscillatory case, systems are stable when the solute diffusivity ratio is smaller than one. If solute diffusivity is higher in water, the oscillatory stability depends on the kinematic viscosity ratio and the sign of the product of the heat of solution and the thermal interfacial tension coefficient. Systems with negative product are stable for the viscosity ratio smaller than one and could be unstable for the viscosity ratio larger than one. Instability may set in as overstability in systems with positive product for arbitrary viscosity ratio. In the case of equal solute diffusivities in both phases, the stationary stability of the systems depends on the sign of this product. Systems with negative product are stable whereas in systems with positive product stationary convection may appear. The oscillatory stability of systems with equal solute diffusivities depends only on the viscosity ratio. They are stable when kinematic viscosity is lower in the aqueous phase than in the organic phase and oscillatory instability may occur if kinematic viscosity is higher in the aqueous phase. The stability criteria are applied to three liquid-liquid systems contaminated with two surfactants and the theoretical predictions are compared against experimental observations. (c) 2006 Elsevier B.V. All rights reserved.
机译:研究了在存在表面活性溶质的情况下,在部分混溶的液-液系统(例如有机-水系统)中Marangoni不稳定的发生。有机相最初用水预先饱和,并在两相接触后在水相中扩散。水相被表面活性的溶质污染,该溶质也可溶于有机相,因此转移穿过液体之间的界面。由于溶液的热量和溶质的界面活性,界面张力梯度可能会导致这些系统中的马兰戈尼不稳定。在目前的工作中,考虑了降低界面张力的溶质。对稳态和振荡扰动都进行了线性稳定性分析,并以解析形式导出了相应的特征方程。对它们进行了数值分析,以获取所涉及物理参数的典型值。结果表明,稳定性条件主要取决于系统的三个物理参数:溶质扩散率,运动粘度比以及溶液热和热界面张力系数的乘积。在固定情况下,当溶质扩散率大于1时,系统是稳定的,与粘度比的大小无关,并且如果溶质扩散率在水相中比在有机相中低,则系统可能会不稳定。在振荡情况下,当溶质扩散率小于1时,系统是稳定的。如果溶质在水中的扩散率较高,则振荡稳定性取决于运动粘度比以及溶液热和热界面张力系数乘积的符号。负积的系统对于小于1的粘度比是稳定的,而对于大于1的粘度比可能是不稳定的。对于具有任意粘度比的积为正值的系统,不稳定可能会设置为过稳定性。在两相的溶质扩散率相等的情况下,系统的静态稳定性取决于该乘积的符号。积为负的系统是稳定的,而积为正的系统可能会出现固定对流。具有相同溶质扩散率的系统的振荡稳定性仅取决于粘度比。当水相中的运动粘度较低时,它们是稳定的;而水相中的运动粘度较高时,则可能发生振荡不稳定。将稳定性标准应用于受两种表面活性剂污染的三个液-液系统,并将理论预测与实验观察结果进行比较。 (c)2006 Elsevier B.V.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号