Air Bearing Slider-Disk Interface for Single-Sided High Speed Recording on a Metal Foil Disk

摘要

There are disk-drive data storage applications best served by single-sided recording configurations. These include situations where (i) storage requirements can be achieved on a single side of a disk and (ii) dimensional constraints on the disk drive prohibit the presence of a recording head and its associated mounting device on each side of the disk. Even if dimensional requirements are not a concern, the most cost-effective and operationally efficient slider-disk air-bearing interface for single-sided recording is one that does not include an air-bearing slider, pressure pad, or other air-bearing structure on the nondata side of the disk. A metal foil disk offers some of the best characteristics of both the hard disk and floppy disk for digital data storage. It offers hard disk recording densities, increased shock resistance, reduced manufacturing cost, and requires less operational energy than a hard disk. However, use of a conventional recording head slider assembly without opposing air-bearing support for single-sided recording on a high-speed metal foil disk presents a fundamental problem because the air-bearing surface of the slider produces a net transverse force to the disk. This force causes the disk to deflect and can result in flying height and stability problems at the slider-disk interface. The current work describes an air-bearing interface for low flying height single-sided recording on a high-speed metal foil disk that minimizes disk deflection and instability without the presence of air-bearing components on opposing sides of the disk. The new interface utilizes a vacuum cavity-type air-bearing with little or no preload. Examples will be presented and discussed for the new interface that illustrate the flying characteristics of a picosized slider on a 1.8 in. stainless steel disk with thickness of 25.4 μm.