INVESTIGATION OF ELECTRON PARALLEL PRESSURE BALANCE IN THE SCRAPEOFF LAYER OF DEUTERIUM-BASED RADIATIVE DIVERTOR DISCHARGES IN DIII-D

摘要

Electron density, temperature and parallel pressure measurements at several locations along field lines connecting the midplane scrapeoff layer (SOL) with the outer divertor are presented for both attached and partially-detached divertor cases: I-p = 1.4 MA, q(95) = 4.2 and P-input similar to 6.7 MW under ELMing H-mode conditions. At the onset of the Partially Detached Divertor (PDD), a high density, low temperature plasma forms in the divertor SOL (divertor MARFE). The electron pressure drops by a factor of 2 between the midplane separatrix and the X-point and then an additional similar to 3-5 times between the X-point and the outboard separatrix strike point. These results are in contrast to the attached (non-PDD) case, where electron pressure in the SOL is reduced by, at most, a factor of two between the midplane and the divertor target. Divertor MARFEs generally have only marginal adverse impact on important H-mode characteristics, such as confinement time. In fact, PDD discharges at low input power (i.e., approximately twice the L-H-mode threshold power) maintain good H-mode characteristics until a high density, low temperature plasma abruptly forms inside the separatrix near the X-point (X-point MARFE). Concurrent with the appearance of this X-point MARFE is a degradation in both energy confinement and the plasma fueling rate and an increase in the carbon impurity concentration inside the core plasma. The formation of the X-point MARFE is consistent with a thermal instability resulting from the temperature dependence of the carbon radiative cooling rate in the range similar to 7-30 eV. [References: 20]