首页> 外文期刊>Journal of orthopaedic trauma >Crutch weightbearing on comminuted humeral shaft fractures: a biomechanical comparison of large versus small fragment fixation for humeral shaft fractures.
【24h】

Crutch weightbearing on comminuted humeral shaft fractures: a biomechanical comparison of large versus small fragment fixation for humeral shaft fractures.

机译:肱骨干粉碎性骨折的拐杖承重:肱骨干骨折大,小碎片固定的生物力学比较。

获取原文
获取原文并翻译 | 示例
           

摘要

PURPOSE: This study evaluated the failure properties of length unstable humerii secured with small or large fragment plates. METHODS: Two nonlocking plate constructs were examined, a nine-hole 4.5-mm limited contact dynamic compression plate (large fragment group) and a 12-hole 3.5-mm limited contact dynamic compression plate (small fragment group), both on composite humerii with a 1-cm defect to simulate comminution (n = 12 for each group). Each plate construct had similar working lengths and number of fixation points. Mechanical testing was first randomized for stiffness measurements in axial and torsional loads. All constructs were then tested in cyclic axial loads to failure. RESULTS: For axial testing, the large fragment group had a mean stiffness of 1020 +/- 195 N/mm compared with 268 +/- 67 N/mm in the small fragment group (P < 0.0001). For torsional testing, the large fragment group had a mean stiffness of 1.5 +/- 0.05 Nm/degree compared with 0.9 +/- 0.04 Nm/degree in the small fragment group (P < 0.0001). Plastic deformation in the large fragment and small fragment groups were 0.09 +/- 0.07 mm and 0.20 +/- 0.24 mm, respectively (P = 0.1) assessed during cyclic testing up to 300 N. The postcyclic yield force in the large fragment group was 227 +/- 30 N and in the small fragment group was 153 +/- 5 N (P < 0.0001). The ultimate load in the large fragment and small fragment groups were 800 +/- 87 N and 307 +/- 15 N, respectively. CONCLUSION: The results corroborate anticipated plate mechanical behavior with plate stiffness increasing as both plate width and thickness increase. The calculated yield force data suggest that both small and large fragment constructs would experience plastic deformation during bilateral crutch ambulation in a patient weighing 50 kg or more. The large fragment construct is not expected to catastrophically fail when subjected to loads in a patient 90 kg or less. The small fragment construct is predicted to catastrophically fail in patients weighing 70 kg or more.
机译:目的:本研究评估了用大小不一的碎片板固定的长度不稳定的肱骨的失败特性。方法:检查了两个非锁定板结构,一个九孔4.5 mm有限接触动态压缩板(大片段组)和一个十二孔3.5 mm有限接触动态压缩板(小片段组),均在复合肱骨上1厘米的缺陷以模拟粉碎(每组n = 12)。每种板构建物具有相似的工作长度和固定点数。首先将机械测试随机化,以测量轴向和扭转载荷下的刚度。然后,在循环轴向载荷下对所有结构进行测试,以进行破坏。结果:对于轴向测试,大片段组的平均刚度为1020 +/- 195 N / mm,而小片段组的平均刚度为268 +/- 67 N / mm(P <0.0001)。对于扭转测试,大片段组的平均刚度为1.5 +/- 0.05 Nm /度,而小片段组的平均刚度为0.9 +/- 0.04 Nm /度(P <0.0001)。在最大300 N的循环测试过程中,大片段和小片段组的塑性变形分别为0.09 +/- 0.07 mm和0.20 +/- 0.24 mm(P = 0.1)。大片段组的循环后屈服力为227 +/- 30 N,小片段组为153 +/- 5 N(P <0.0001)。大片段和小片段组的最终载荷分别为800 +/- 87 N和307 +/- 15N。结论:结果证实了预期的板材力学性能,随着板材宽度和厚度的增加板材刚度也随之增加。计算得出的屈服力数据表明,重量在50 kg或更大的患者中,小片段构造物和大片段构造物在双侧拐杖移动时都会经历塑性变形。当患者承受90 kg或以下的重量时,预期大片段构建体不会发生灾难性的故障。据预测,小片段构建体在体重70公斤或以上的患者中将发生灾难性的故障。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号