...
首页> 外文期刊>Journal of computational and theoretical nanoscience >Investigation of the Surge Immunity of Monocrystalline Silicon Photovoltaic Modules Using Dark Current-Voltage and 1/f Noise Power Spectrum Density Characteristics
【24h】

Investigation of the Surge Immunity of Monocrystalline Silicon Photovoltaic Modules Using Dark Current-Voltage and 1/f Noise Power Spectrum Density Characteristics

机译:利用暗电流电压和1 / f噪声功率谱密度特性研究单晶硅光伏组件的浪涌抗扰性

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Surge immunity of commercialized p-type monocrystalline Si photovoltaic (PV) modules was investigated using dark current voltage (I-V) and 1/f noise power spectrum density (PSD) characteristics. The IEC 61000-4-5 (IEC: International Electrotechnical Commission) standard method was employed as the surge immunity tests for PV modules assembled with and without the bypass diode. The PV module without bypass diode was capable of withstanding surge test at +/- 6.0 kV with the consistent of insignificant degradation in dark I-V curve and noise PSD level. On the other hand, for the PV module with bypass diode, the leakage current was unchangeable as increasing surge magnitude up to +/- 2 kV. However, after surge test at +/- 3.0 kV, the PV module with bypass diode showed a rapid increase in reverse leakage current and 1/f noise PSD, followed by a complete failure after +/- 3.5 kV. This implied that bypass diode could be a major cause of the PV module failure at high surge voltage stress though they could guard the PV module from the damage of low surge voltage strikes. Namely, the bypass diode for the application of PV modules should guarantee the class 4 (4 kV) of IEC61000-4-5 standard in order to ensure the long-term reliability of PV systems.
机译:利用暗电流电压(I-V)和1 / f噪声功率谱密度(PSD)特性研究了商品化p型单晶硅光伏(PV)模块的抗浪涌性能。采用IEC 61000-4-5(IEC:国际电工委员会)标准方法作为组装有无旁路二极管的PV模块的浪涌抗扰度测试。不带旁路二极管的PV模块能够承受+/- 6.0 kV的电涌测试,并且在暗I-V曲线和噪声PSD电平方面均无明显降低。另一方面,对于带有旁路二极管的PV模块,随着浪涌幅度增加到+/- 2 kV,泄漏电流是不变的。但是,在+/- 3.0 kV的电涌测试后,带有旁路二极管的PV模块显示反向泄漏电流和1 / f噪声PSD迅速增加,然后在+/- 3.5 kV之后完全失效。这意味着旁路二极管可能是高浪涌电压应力下光伏组件故障的主要原因,尽管它们可以保护光伏组件免受低浪涌电压冲击的损害。即,用于光伏模块的旁路二极管应保证IEC61000-4-5标准的4级(4 kV),以确保光伏系统的长期可靠性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号