首页> 外文期刊>Journal of Agricultural and Food Chemistry >Pressure-temperature phase transition diagram for wheat starch.
【24h】

Pressure-temperature phase transition diagram for wheat starch.

机译:小麦淀粉的压力-温度相变图。

获取原文
获取原文并翻译 | 示例
       

摘要

Wheat starch suspensions in water (5% dry matter) were subjected to various pressures (0.1-600 MPa) and temperatures (-20 to 96 degrees C) for 15 min. The gelatinization rate was measured after treatment by using microscopic measurements of the loss of birefringence of the granules. This method was previously calibrated by differential scanning calorimetry. Curves of isogelatinization were found to be quite similar to a pressure-temperature (P-T) diagram of unfolding proteins. Results were first analyzed by considering the thermodynamic aspects related to the dT/dP curve shifts. On the basis of equations already shown for proteins, the P-T gelatinization diagram of wheat starch would show different kinds of thermal contributions, suggesting endothermic, athermic, or exothermic melting reactions. Second, as a practical consequence, these previous P-T areas corresponded to specific gelatinization conditions as confirmed by hydration evaluation measured by starch swelling index. Depending on the pressure-temperature conditions, gelatinization would involve hydration. Lowering the pressure and temperature resulted in a complete gelatinization with less hydration in comparison with a thermal treatment at atmospheric pressure. A hydration model based on an energetic approach was proposed.
机译:将小麦淀粉在水(5%干物质)中的悬浮液置于各种压力(0.1-600 MPa)和温度(-20至96摄氏度)下15分钟。在处理后,通过使用显微镜测量颗粒的双折射损失来测量糊化率。该方法先前已通过差示扫描量热法进行了校准。发现异糊化的曲线与展开蛋白的压力-温度(P-T)图非常相似。首先通过考虑与dT / dP曲线位移有关的热力学方面来分析结果。根据已经显示的蛋白质方程式,小麦淀粉的P-T糊化图将显示不同类型的热作用,表明吸热,热解或放热熔融反应。其次,作为实际结果,这些先前的P-T区域对应于特定的糊化条件,如通过淀粉溶胀指数测量的水合评价所证实的。取决于压力-温度条件,糊化将涉及水合。与在大气压下进行热处理相比,降低压力和温度可导致完全的糊化和更少的水合作用。提出了一种基于能量学方法的水化模型。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号