首页> 外文期刊>JOM >Synchronous Volatilization of Sn, Zn, and As, and Preparation of Direct Reduction Iron (DRI) from a Complex Iron Concentrate via CO Reduction
【24h】

Synchronous Volatilization of Sn, Zn, and As, and Preparation of Direct Reduction Iron (DRI) from a Complex Iron Concentrate via CO Reduction

机译:锡,锌和砷的同步挥发,以及通过一氧化碳还原从复杂的铁精矿中制备直接还原铁(DRI)

获取原文
获取原文并翻译 | 示例
           

摘要

Sn-, Zn-, and As-bearing iron ores are typical complex ores and are abundantly reserved in China. This kind of ore is difficult to use effectively due to the complicated relationships between iron and the other valuable metal minerals. Excessive Sn, Zn, and As contents would adversely affect ferrous metallurgy operation as well as the quality of the products. In this study, thermodynamic calculations revealed that it was feasible to synchronously volatilize Sn, Zn, and As via CO reduction. Experimental results showed that preoxidation was necessary for the subsequent reductive volatilization of Zn from the pellets, and the proper preoxidation temperature was 700-725A degrees C under air atmosphere. Synchronous volatilization of Sn, Zn, and As was realized by roasting under weak reductive atmosphere after the pellets were preoxidized. The volatilization ratios of 75.88% Sn, 78.88% Zn, and 84.43% As were obtained, respectively, under the conditions by reduction at 1000A degrees C for 100 min with mixed gas of 50% CO + 50% CO2 (in vol.). A metallic pellet (direct reduction iron) with total iron grade of 87.36%, Fe metallization ratio of 89.27%, and residual Sn, Zn, and As contents of 0.071%, 0.009%, and 0.047%, respectively, was prepared. Sn and As were mainly volatilized during weak reductive atmosphere roasting, and those volatilized in the metallization reduction process were negligible. Most of Zn (78.88%) was volatilized during weak reductive atmosphere roasting, while the metallization reduction process only contributed to 16.10% of total Zn volatilization.
机译:含锡,含锌和含砷的铁矿石是典型的复杂矿石,在中国储量丰富。由于铁与其他有价金属矿物之间的复杂关系,这种矿石难以有效利用。 Sn,Zn和As含量过多会不利地影响黑色金属冶炼操作以及产品质量。在这项研究中,热力学计算表明,通过还原CO同步挥发Sn,Zn和As是可行的。实验结果表明,预氧化对于随后的锌从丸粒中的还原挥发是必需的,并且在空气气氛下合适的预氧化温度为700-725A℃。颗粒预氧化后,在弱还原气氛下焙烧可实现Sn,Zn和As的同步挥发。在50%CO + 50%CO2(体积)的混合气体中,在1000℃下还原100分钟的条件下,分别得到75.88%的Sn,78.88%的Zn和84.43%的As的挥发比。制备了金属粒料(直接还原铁),其总铁品位为87.36%,Fe的金属化率为89.27%,残留的Sn,Zn和As含量分别为0.071%,0.009%和0.047%。 Sn和As主要在弱还原气氛焙烧中挥发,而在金属还原过程中挥发的则可以忽略不计。在弱还原性气氛焙烧中,大部分锌(78.88%)挥发,而金属化还原过程仅占全部锌挥发的16.10%。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号