Relationship of wear properties to basal-plane texture of worn surface of Mg alloys

摘要

The wear properties of pure-Mg, AZ31 extruded alloy, AZ91 cast alloy, and Mg_(90.5)Cu_(3.25)Y_(6.25) (at.%) cast alloy consisting of Mg and long-period-ordered (LPO) phases were investigated by pin-on-disk-type wear tests under dry sliding. The wear loss of the Mg_(90.5)Cu_(3.25)Y_(6.25) cast alloy at high-applied loads over 147 N was less than those of AZ Mg alloys, and about two-thirds of the AZ31 extruded alloy, which indicated that the Mg_(90.5)Cu_(3.25)Y_(6.25) cast alloy has superior wear-resistance. The basal planes (0002) and (1011) were apparent in the X-ray diffraction patterns of worn surfaces of pure-Mg and Mg alloys. This XRD result indicated that basal planes in both the Mg and LPO phases were aligned to worn surfaces for the pure-Mg and Mg alloys, and this result was also supported by EBSD analysis. Because slip deformation tends to easily occur on the Mg basal plane at a low critical resolved shear stress (CRSS), formation of the basal-plane alignment on the wear surface negatively affects the wear-resistance properties. After the wear test of the Mg_(90.5)Cu_(3.25)Y_(6.25) cast alloy, a kink deformation in the LPO phase was frequently observed in the worn edge section. The kink deformation in the LPO phase contributes to improve wear-resistance properties by suppression of the basal-plane alignment.