...
首页> 外文期刊>Tissue engineering, Part C. Methods >Bone tissue engineering in oral surgery: a new method of bone development in periodontal surgery.
【24h】

Bone tissue engineering in oral surgery: a new method of bone development in periodontal surgery.

机译:口腔手术中的骨组织工程:牙周手术中骨发育的新方法。

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

This article describes the development of a new surgical approach to periodontal treatment. Twenty patients who suffered from bone defects without existing bony walls due to adult periodontitis were treated in three different groups using methods of bone tissue engineering. At that time no surgical technique existed that could be applied to those patients to generate new bone. The periodontal surgeries were performed between 2004 and 2008. All patients received follow-up examinations at 6, 12, and 24 months after surgical procedure. Measured parameters were compared to baseline. The surgical approach and the augmentation material have been improved based on the results of the previous group. This strategy was applied because of the ethical fact that a medical treatment of patients has to be carried out with the knowledge and experience of previous settings. All groups received recombinant human bone morphogenetic protein 2 and platelet-rich plasma. The above-mentioned procedure had been approved in other indications in the field of oral and maxillofacial surgery. The first group underwent conventional muco-periosteal flap technique and obtained an augmentation with absorbable collagen sponge (ACS). The second and third groups were treated using endoscopically assisted microsurgery due to wound healing disturbances that appeared in the first group. The augmentation was carried out with demineralized bone matrix (DBM) instead of ACS (group 2) or tricalciumphosphate as a further development instead of DBM (group 3). The radiological control 12 months (group 1), 18 months (group 2), and 2 years (group 3) after surgery proved the following results-first group: 1.7 mm (average) vertical bone development (VBD); second group: 2.5 mm (average) VBD; third group: 3.2 mm (average) VBD. These results of single patient treatment open new ways into periodontal surgery. They have to be confirmed by prospective case series and multicenter studies.
机译:本文介绍了一种新的牙周治疗手术方法的发展。使用骨组织工程方法将20例由于成人牙周炎而患有骨缺损而没有现有骨壁的患者分为三组。当时尚无可用于这些患者产生新骨的手术技术。牙周手术于2004年至2008年进行。所有患者均在手术后6、12和24个月接受了随访检查。将测得的参数与基线进行比较。根据前一组的结果,对手术方法和增强材料进行了改进。之所以采用这种策略,是因为出于道德上的事实,必须根据先前的知识和经验对患者进行医疗。所有组均接受重组人骨形态发生蛋白2和富含血小板的血浆。上述方法已经在口腔颌面外科领域的其他适应症中得到认可。第一组接受常规的粘膜-骨膜瓣技术,并使用可吸收的胶原海绵(ACS)进行增强。由于第一组中出现的伤口愈合障碍,使用内窥镜辅助显微外科手术治疗第二和第三组。用去矿质骨基质(DBM)代替ACS(第2组)或用磷酸三钙代替DBM(第3组)进行增强。术后12个月(第1组),18个月(第2组)和2年(第3组)的放射控制证明了以下结果:第一组:1.7毫米(平均)垂直骨发育(VBD);第二组:2.5 mm(平均)VBD;第三组:3.2毫米(平均)VBD。单例治疗的这些结果为牙周手术开辟了新途径。必须通过前瞻性病例系列研究和多中心研究来证实它们。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号