Comparative study of interlaminar fracture toughness of GFRP with different fiber surface treatments

摘要

This investigation is focused on the influence of glass fiber surface treatment on the interlaminar fracture toughness of unidirectional laminates. Three different fiber surface treatments were considered: polyethylene treated fibers to get poor adhesion, silane treated fibers to get good bond strength, and industrial fibers without special treatments with the coupling agents. The interlaminar fracture behavior of unidirectional glass fiber reinforced composites with different fiber surface treatments has been investigated in mode I, mode II, and for the fixed mixed mode I/II ratio 1.33. Double cantilever beam (DCB), end notched flexure (ENF), and mixed mode flexure (MMF) specimens were used. The data obtained from these tests were analyzed by using different analytical approaches and the finite element method. For the fibers treated with the silane coupling agent, a value about 2.5 times higher of mode II interlaminar fracture toughness for crack initiation was obtained in comparison with the polyethylene sized composite. For the composite made from the industrial fibers, a value about 2 times higher was obtained. Because of extensive fiber bridging and pullout in the composites with poor fiber/matrix adhesion, the results of mode I and mixed mode I/II tests did not characterize the interphase quality. In order to determine the interphase quality, the mode II tests are recommended. [References: 41]