...
首页> 外文期刊>Physiological and Molecular Plant Pathology >Early adhesion of Blumeria graminis to plant and artificial surfaces demonstrated by centrifugation
【24h】

Early adhesion of Blumeria graminis to plant and artificial surfaces demonstrated by centrifugation

机译:离心证明了Blumeria graminis在植物和人造表面上的早期粘附

获取原文
获取原文并翻译 | 示例

摘要

The relative strength of adhesion by Blumeria graminis conidia and germlings to barley leaves and to clean (hydrophilic) or silanized (hydrophobic) glass, was assessed using centrifugation. Ungerminated conidia were incubated for 10 or 30 min before centrifugation, while extended incubation, for up to 12 h, allowed germlings to reach different developmental stages before treatment. After incubation, mounts were Subjected to relative centrifugal force (RCF) ranging from 0.13 x 10(3) to 26.00 x 10(3). Two key features indicating adhesion strength were the minimum RCT required for displacement of any fungal units, and the percentage of these displaced by the maximum RCF. By these criteria, adhesion was far stronger after germination, presumably because germ tubes adhered to substrata. Ultimately, germlings adhered more strongly to leaves, where appressoria differentiated, than to clean glass where only multiple short germ tubes were formed. Ungerminated conidia adhered relatively weakly to host leaves and most strongly to silanized glass. Increasing incubation time did not increase their adhesion to leaves but conidia incubated for 30 min adhered more strongly to clean and silanized glass than those incubated for only 10 min. Thus, in general, the strength of adhesion by ungerminated conidia correlated to known differences in the speed of conidial extracellular material (ECM) release and to the quantity of ECM released on the different substrata. However, even on leaves where ungerminated conidia showed the weakest adhesion, about 80% of conidia were not displaced by RCF of 0.13 x 10(3). Under these circumstances conidia had been subject to about 4.2 x 10(-9) N force acting to displace them. This is tar greater than the forces likely to be generated by wind acting on conidia deposited on the leaves of a barley crop. Thus, adhesion by Ungerminated conidia is sufficient to hold the majority of spores in place even under very windy field conditions.
机译:使用离心法评估了Blumeria graminis分生孢子和种苗对大麦叶片以及清洁(亲水)或硅烷化(疏水)玻璃的粘附的相对强度。离心前将未萌发的分生孢子孵育10或30分钟,同时延长孵育时间长达12小时,使幼苗在处理前达到不同的发育阶段。孵育后,将座架置于0.13 x 10(3)至26.00 x 10(3)的相对离心力(RCF)范围内。指示粘附强度的两个关键特征是任何真菌单位置换所需要的最小RCT,以及被最大RCF置换的百分比。按照这些标准,发芽后的粘附力要强得多,大概是因为胚芽管粘附在了基质上。最终,胚芽比仅形成多个短胚芽管的清洁玻璃更牢固地附着在有明显压感的叶子上。未发芽的分生孢子相对较弱地粘附在寄主叶片上,最牢固地粘附在硅烷化玻璃上。延长孵育时间不会增加其对叶片的附着力,但是孵育30分钟的分生孢子比仅孵育10分钟的分生孢子更牢固地粘附在干净的硅烷化玻璃上。因此,一般而言,未萌发的分生孢子的粘附强度与分生孢子细胞外物质(ECM)释放速度的已知差异以及在不同基质上释放的ECM量有关。然而,即使在未发芽的分生孢子表现出最弱粘附力的叶子上,约80%的分生孢子也不会被0.13 x 10(3)的RCF取代。在这种情况下,分生孢子要承受大约4.2 x 10(-9)N的力来移动它们。焦油比风可能对沉积在大麦作物叶片上的分生孢子产生的作用力要大。因此,即使在多风的田野条件下,未萌发的分生孢子的粘附也足以将大部分孢子固定在适当的位置。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号