...
首页> 外文期刊>IEEE Journal of Solid-State Circuits >A 3.5-GHz PLL for Fast Low-IF/Zero-IF LO Switching in an 802.11 Transceiver
【24h】

A 3.5-GHz PLL for Fast Low-IF/Zero-IF LO Switching in an 802.11 Transceiver

机译:用于802.11收发器中的快速低中频/零中频LO切换的3.5GHz PLL

获取原文
获取原文并翻译 | 示例

摘要

A PLL technique is introduced that enables fast and accurate frequency switching, independent of the loop bandwidth. It uses separate tuning paths, each driving a separate VCO tune port. Different frequencies are produced by letting the VCO make different weighted combinations of the stable tuning voltages. The PLL converges to the stable tuning voltages by switching it a few times between the desired frequencies and tuning paths. Once the stabilized tuning voltages are found, one can switch between frequencies as fast as one can switch between K{sub}(vco)s. The technique is applied to a 3.5-GHz integer-AT PLL to enable fast jumping of the local oscillator (LO) frequency when an 802.11 transceiver is switched between a low and a zero intermediate frequency (LIF/ZIF). It uses dual phase/frequency detectors (PFD), charge pumps (CPs), and on-chip loop filters to control two separate low-leakage VCO tune ports. Each PFD/tune port combination can be (de)activated separately, without disturbing the loop filters' charge. The 50-kHz bandwidth PLL achieves a measured 7-MHz jump with ±20 kHz accuracy within 6 /us. The measured phase noise is -123 dBc/Hz at 1-MHz offset.
机译:引入了一种PLL技术,该技术可实现独立于环路带宽的快速准确的频率切换。它使用单独的调整路径,每个路径驱动一个单独的VCO调整端口。通过使VCO对稳定的调谐电压进行不同的加权组合,可以产生不同的频率。 PLL通过在所需频率和调谐路径之间切换几次来收敛到稳定的调谐电压。一旦找到稳定的调谐电压,就可以在频率之间切换,就像在K {v} s之间切换一样快。将该技术应用于3.5 GHz整数AT PLL,以在802.11收发器在低频和零中频(LIF / ZIF)之间切换时实现本地振荡器(LO)频率的快速跳变。它使用双相/频率检测器(PFD),电荷泵(CP)和片上环路滤波器来控制两个独立的低泄漏VCO调谐端口。每个PFD /调谐端口组合都可以单独(取消)激活,而不会影响环路滤波器的电荷。 50kHz带宽PLL在6μs/μs内实现了±20kHz精度的7MHz跳变。在1MHz偏移处测得的相位噪声为-123 dBc / Hz。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号