The paper gives the results of room-temperature measurements on ceramic (polycrystalline) specimens of magnesium, calcium, strontium and barium titanates at frequencies of 1.5 and 9450 Mc/s (3.18 cm), and on barium titanate at 24000 Mc/s (1.25 cm). It is found that the latter material is unique among this series in showing a considerable fall in permittivity, and a large increase in the loss tangent, at the higher frequencies, compared with the behaviour at 1.5 Mc/s. Variable temperature measurements on barium titanate show that the crystallo-graphic change which is known to occur around 120???????°C, the Curie point of the material, affects the permittivity at 9450 and 1.5 Mc/s in an analogous manner. Room-temperature measurements at the same frequencies on a range of barium-strontium titanate compositions are also described, and attention is drawn to the composition 56% BaTiO3: 44% SrTiO3, having a permittivity of 760 and loss tangent of 0.02 at 9450 Mc/s and 20???????°C, as likely to be of value in microwave work. The difficulties associated with the measurement of high-permittivity values at centimetre wavelengths are discussed, and a full description is given of the three methods developed for different parts of the investigation.
展开▼
机译:本文给出了在镁,钙,锶和钛酸钡的陶瓷(多晶)样品上以1.5和9450 Mc / s(3.18 cm)的频率进行室温测量的结果,以及在24000 Mc / s(1.25)下的钛酸钡的室温测量结果。厘米)。已发现,在更高的频率下,与1.5 Mc / s的行为相比,后一种材料在该系列中具有独特之处,表现出介电常数显着下降,损耗角正切大幅度增加。在钛酸钡上进行的可变温度测量表明,已知在材料的居里点120°C附近发生的晶体学变化会在9450和1.5 Mc / s下影响介电常数。方式。还描述了一系列钛酸钡锶锶组成在相同频率下的室温测量,并引起注意的是组成为56%BaTiO3:44%SrTiO3,在9450 Mc /时的介电常数为760,损耗角正切为0.02。 s和20°C的温度,可能在微波工作中很有价值。讨论了与在厘米波长处测量高介电常数有关的困难,并全面介绍了针对研究的不同部分开发的三种方法。
展开▼