Apatite and Portland/apatite composite cements obtained using a hydrothermal method for retaining heavy metals

摘要

Apatite and Portland/apatite composite cements containing steelwork dusts have been prepared using a low temperature hydrothermal method (200℃, 48 h). The produced solids were characterized by means of XRD, IR, and SEM-EDX, and the remaining liquid was analyzed by ICP. The results clearly show the capability of these cements to inertise the heavy metals contained in steelwork dusts, that is Fe, Pb, Mo, Cr, Mn, Ni, and Zn. In the case of apatitic cements, Fe, Mg, Cr, Mn, and Pb coming from steel dust replaced Ca in the divalent cation position of the apatite structure, while Si and Mo replaced P in tetrahedral position. The average crystal size of the apatite-containing dust is smaller than in pure apatite synthesized using the same procedure, which is related to the magnesium content of the dust, since magnesium seems to inhibit the crystal growth. XRD diagrams of composite cements show only peaks corresponding to phases observed in the single cements, and in that no new phases are found. However, EDX analysis reveals the introduction of cations coming from Portland cement into the apatite structure. From the results of water analysis it could be concluded that the capability of retention is higher in composite matrices than in the pure apatite one. In conclusion, the obtained data allow stating that the proposed method, the hydrothermal synthesis of steelwork dust containing cement, is a reliable one for immobilization of toxic residues containing heavy leachable cations.