Applicability of a continuous-flow system inner-coated with S-doped titania for the photocatalysis of dimethyl sulfide at low concentrations

摘要

The present study investigated the photocatalytic activity of an S-doped TiO_2 photocatalyst with regards to dimethyl sulfide degradation under visible-light irradiation, along with its deactivation and reactivation. The dimethyl sulfide conversion was between 85% and 93% for the lowest relative humidity range (10-20%) and close to 100% for the two higher relative humidity ranges (45-55% and 80-90%). The conversion was also close to 100% for the two lowest input concentrations (0.039 and 0.195 ppm), while it was between 91% and 96% at 3.9 ppm and between 85% and 90% at 7.9 ppm. In contrast to the input concentration dependences on conversion, the calculated degradation rates increased as input concentrations increased. The dimethyl sulfide conversion at low concentrations (≤0.39 ppm), which are associated with non-occupational inn occurring. However, catalyst deactivations were observed during the photocatalytic process whdoor air quality issues, was up to nearly 100% for long time periods (at least 603 h), without any significant catalyst deactivatioen higher concentrations (3.9 and 7.8 ppm) were used. The photocatalyst, reactivated by using two types of air (dried and humidified) under visible-light irradiation, did not regain all of its initial activities. Sulfate groups were qualitatively identified as the reaction products on the photocatalyst surface. In addition, gaseous byproducts, quantitatively determined, included dimethyl disulfide, methanol, and SO_2. It is noteworthy that the peak concentration of dimethyl disulfide (0.79 ppm = 790 ppb), generated over the photocatalytic process with the highest dimethyl sulfide input concentration, exceeded the odor threshold value of 0.1-3.6 ppb for dimethyl disulfide.