...
首页> 外文期刊>Journal of Applied Physics >In situ spectroscopic ellipsometry study on the growth of ultrathin TiN films by plasma-assisted atomic layer deposition
【24h】

In situ spectroscopic ellipsometry study on the growth of ultrathin TiN films by plasma-assisted atomic layer deposition

机译:等离子体辅助原子层沉积法原位光谱椭偏法研究超薄TiN薄膜的生长

获取原文
获取原文并翻译 | 示例
           

摘要

The growth of ultrathin TiN films by plasma-assisted atomic layer deposition (PA-ALD) was studied by in situ spectroscopic ellipsometry (SE). In between the growth cycles consisting of TiCl_4 precursor dosing and H_2-N_2 plasma exposure, ellipsometry data were acquired in the photon energy range of 0.75-5.0 eV. The dielectric function of the TiN films was modeled by a Drude-Lorentz oscillator parametrization, and the film thickness and the TiN material properties, such as conduction electron density, electron mean free path, electrical resistivity, and mass density, were determined. Ex situ analysis was used to validate the results obtained by in situ SE. From the in situ spectroscopic ellipsometry data several aspects related to thin film growth by ALD were addressed. A decrease in film resistivity with deposition temperature between 100 and 400℃ was attributed -to the increase in electron mean free path due to a lower level of impurities incorporated into the films at higher temperatures. A change in resistivity and electron mean free path was observed as a function of film thickness (2-65 nm) and was related to an increase in electron-sidewall scattering for decreasing film thickness. The TiN film nucleation was studied on thermal oxide covered c-Si substrates. A difference in nucleation delay was observed on these substrates and was related to the varying surface hydroxyl density. For PA-ALD on H-terminated c-Si substrates, the formation of an interfacial SiN_x film was observed, which facilitated the TiN film nucleation.
机译:通过原位光谱椭偏仪(SE)研究了通过等离子体辅助原子层沉积(PA-ALD)生长的超薄TiN薄膜。在由TiCl_4前驱物剂量和H_2-N_2等离子体暴露组成的生长周期之间,在0.75-5.0 eV的光子能量范围内获得了椭圆光度法数据。通过Drude-Lorentz振荡器参数化对TiN薄膜的介电功能进行建模,并确定薄膜厚度和TiN材料性能,例如传导电子密度,电子平均自由程,电阻率和质量密度。使用异位分析来验证通过原位SE获得的结果。从原位椭圆偏振光谱数据可以看出,与ALD薄膜生长有关的几个方面。沉积温度在100到400℃之间时,薄膜电阻率的下降归因于-由于在较高温度下掺入薄膜中的杂质含量降低,电子平均自由程增加。观察到电阻率和电子平均自由程的变化是膜厚度(2-65 nm)的函数,并且与电子侧壁散射的增加相关,从而减小了膜厚度。在热氧化物覆盖的c-Si衬底上研究了TiN薄膜的成核作用。在这些基材上观察到成核延迟的差异,并且与表面羟基密度的变化有关。对于在氢封端的c-Si衬底上的PA-ALD,观察到界面SiN_x膜的形成,这有助于TiN膜成核。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号