首页> 外文期刊>Japanese journal of applied physics >Influence Of Cuo Addition And Sintering Temperature On Microwave Dielectric Properties Of Ca_(0.99)zn_(0.01)la_4ti_5o_(17) Ceramics For Application In Stacked Patch Antenna
【24h】

Influence Of Cuo Addition And Sintering Temperature On Microwave Dielectric Properties Of Ca_(0.99)zn_(0.01)la_4ti_5o_(17) Ceramics For Application In Stacked Patch Antenna

机译:Cu添加量和烧结温度对叠层贴片天线用Ca_(0.99)zn_(0.01)la_4ti_5o_(17)陶瓷微波介电性能的影响

获取原文
获取原文并翻译 | 示例
获取外文期刊封面目录资料

摘要

In this study, the microwave dielectric properties of Ca_(0.99)Zn_(0.01)La_4Ti_5O_(17) (CZLTO) ceramics have been investigated. It is found that the X-ray diffraction pattern exhibited no phase difference with 0.5 wt % CuO additive at different sintering temperatures. The maximum value of the dielectric constant and the quality factor Q x f can be obtained with 0.5 wt % CuO additive and sintered at 1450℃ for 4h. A τ_f of - 8.16ppm/℃ was measured for CZLTO ceramics with 0.5wt% CuO sintered at 1450 ℃ for 4 h. The measurement results for a stacked patch antenna at 2.45 GHz are presented. With this technique, a 3.3% bandwidth (return loss < - 10 dB) with a center frequency at approximately 2.45 GHz has been successfully achieved. The peak antenna gain is approximately 2.2 dBi, with gain variations of less than 1.0 dBi for frequencies within in the -10 dB S_(11) bandwidth.
机译:本文研究了Ca_(0.99)Zn_(0.01)La_4Ti_5O_(17)(CZLTO)陶瓷的微波介电性能。发现在不同的烧结温度下,使用0.5wt%的CuO添加剂,X射线衍射图没有表现出相差。介电常数的最大值和品质因数Q x f可以用0.5 wt%的CuO添加剂获得,并在1450℃下烧结4h。对于0.5wt%CuO在1450℃烧结4 h的CZLTO陶瓷,测得的τ_f为-8.16ppm /℃。给出了2.45 GHz堆叠式贴片天线的测量结果。通过这种技术,已经成功实现了中心频率约为2.45 GHz的3.3%带宽(回波损耗<-10 dB)。天线的峰值增益约为2.2 dBi,对于-10 dB S_(11)带宽内的频率,增益变化小于1.0 dBi。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号