首页> 外文期刊>Geosynthetics International >Influence of fibers on the shear strength and dewatering performance of geotextile tubes
【24h】

Influence of fibers on the shear strength and dewatering performance of geotextile tubes

机译:纤维对土工布管材抗剪强度和脱水性能的影响

获取原文
获取原文并翻译 | 示例
           

摘要

Geotextile tubes have been widely used for the dewatering of high water content fine sediments. Fine sediments include lake sediments, organic soils and coal combustion products, which generally have low shear strength. Several researchers have emphasized the effect of the retained sediment (filter cake) properties on dewatering performance and stability of the geotextile tubes. Maintaining retained sediment properties, in particular permeability and shear strength, allows for faster dewatering time, better retention of sediments and improved stability of the geotextile tubes during multiple filling stages and during the tube stacking process. Several studies have shown that the use of synthetic fibers can increase the shear strength of sand, silt and clays. However, the use of fibers to improve the strength of retained sediments in geotextile tubes has not been explored. In this study, three synthetic fibers varying in length and diameter were used to evaluate the effect of fibers on the dewatering performance and shear strength of the fine sediments. A cationic polyacrylamide flocculant was used as an optimum conditioner for the selected sediment. The fibers were mixed with the flocculant conditioned slurry at 0.25, 0.5, 1 and 2% fiber concentration by mass of the dry solids. The effect of fibers on the undrained shear strength of the dewatered sediments was evaluated using a lab vane test, fall cone test and undrained unconsolidated triaxial test. Jar tests and pressure filtration tests were also conducted to evaluate the effect of fiber on the required flocculant dosage and on the dewatering performance. Based on the results of this study, 0.5% of F1 fiber type was found to be the optimum fiber concentration, yielding an approximately 100% increase in undrained shear strength. It was also found that the diameter and length of the fibers play a significant role in altering the undrained shear strength of the tested sediments. The relatively short (6 mm) and thick (38 mu m) fiber did not yield an increase in shear strength for all the tested fiber concentrations, whereas thin fibers (9 mu m) of similar length increased the shear strength by 100%. Furthermore, it was found that the use of fibers at any concentration decreases the required optimum doses of flocculant by about 15%, and increases the dewatering rate of the effluents by about 50%.
机译:土工布管已被广泛用于高含水量细沉积物的脱水。精细的沉积物包括通常具有低剪切强度的湖泊沉积物,有机土壤和煤燃烧产物。几位研究人员强调了保留的沉积物(滤饼)性质对土工布管的脱水性能和稳定性的影响。保持保留的沉积物特性,尤其是渗透性和剪切强度,可以加快脱水时间,更好地保留沉积物,并在多个填充阶段和管堆叠过程中改善土工布管的稳定性。多项研究表明,使用合成纤维可以提高沙子,粉砂和粘土的剪切强度。然而,尚未探索使用纤维来改善土工布管中保留的沉积物的强度。在这项研究中,使用三种长度和直径不同的合成纤维来评估纤维对细沙的脱水性能和剪切强度的影响。阳离子聚丙烯酰胺絮凝剂用作所选沉积物的最佳调节剂。将纤维与絮凝剂处理过的浆料以干燥固体质量的0.25、0.5、1和2%纤维浓度混合。纤维对脱水沉积物不排水剪切强度的影响采用实验室叶片试验,落锥试验和不排水不固结三轴试验进行了评估。还进行了广口瓶测试和压力过滤测试,以评估纤维对所需絮凝剂用量和脱水性能的影响。根据这项研究的结果,发现0.5%的F1纤维类型是最佳纤维浓度,不排水剪切强度提高了约100%。还发现,纤维的直径和长度在改变测试沉积物的不排水剪切强度方面起着重要作用。在所有测试的纤维浓度下,相对较短(6毫米)和较粗(38微米)的纤维都不会提高剪切强度,而具有相似长度的细纤维(9微米)却将剪切强度提高了100%。此外,发现使用任何浓度的纤维可使所需的絮凝剂最佳剂量减少约15%,并使废水的脱水率增加约50%。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号