首页> 外文期刊>Geotextiles and Geomembranes >The efficacy and use of small centrifuge for evaluating geotextile tube dewatering performance
【24h】

The efficacy and use of small centrifuge for evaluating geotextile tube dewatering performance

机译:小型离心机评估土工布管脱水性能的功效和用途

获取原文
获取原文并翻译 | 示例
       

摘要

Geotextile tube dewatering technology has been widely used over the past two decades for dewatering high water content slurries. The dewatering process in geotextile tubes aims to decrease the volume of the dewatered slurry, which helps in the transportation, disposal, and reuse of the dewatered material. Several researchers have emphasized the effect of the retained sediment (filter cake) properties, in particular final solids content and volume (height)" change, on the feasibility of geotextile tube dewatering projects. Retained sediment properties are often evaluated using small scale tests such as rapid dewatering test, falling head test, pressure filtration test (PFT), and field scale tests such as hanging bag test (HBT) and geotextile tube demonstrations test (GDT). In this study, centrifuge test is introduced as an alternative for the widely used pressure filtration and falling head tests to evaluate retained sediments properties. Centrifuge test provides a mechanism for understanding the response of slurries to externally applied pressure in geotextile tube environment. Centrifuge test was used to evaluate maximal solids content of the retained sediments and change in slurry volume of four soils that represent typical dredged soils. Tully sand, Tully fines, Elliott silt loam, and kaolin slurries were used at varying solids concentrations. Slurries were subjected to external stresses between 0.1 and 40 kPa by applying centrifugal speeds between 300 rotation per minute (rpm) and 1800 rpm. Both centrifuge test and PFT were conducted with unconditioned and cationic polyacrylamide conditioned slurries. Centrifuge tests results were compared with PFT results with respect to retained sediments final solids content and volume change. Tests results indicated that the maximal solids concentration of the retained sediments in saturated conditions is unique for each soil and is independent of the initial slurry solids concentration. Tests results also indicated that there is linear relationship between the initial concentration of the slurry and the final volume change at any externally applied stress. Finally, a relationship between the total pumped slurry volume and the final height of the dewatered sediments in a geotextile tube is presented. (C) 2017 Elsevier Ltd. All rights reserved.
机译:在过去的二十年中,土工布管脱水技术已广泛用于脱水高含水量的浆料。土工布管中的脱水过程旨在减少脱水浆料的体积,这有助于脱水材料的运输,处置和再利用。几位研究人员强调了保留的沉积物(滤饼)特性,尤其是最终固体含量和体积(高度)“变化”对土工布管脱水项目可行性的影响。保留的沉积物特性通常通过小规模试验来评估,例如快速脱水测试,落头测试,压力过滤测试(PFT)以及现场规模测试,例如吊袋测试(HBT)和土工布管演示测试(GDT),在这项研究中,离心测试被广泛采用使用压力过滤和落头试验来评估保留的沉积物特性。离心试验提供了一种机制来了解泥浆在土工布管环境中对外部施加压力的响应。离心试验用于评估保留的沉积物中最大固体含量和浆液变化代表典型疏dr土壤的四种土壤的体积:塔利沙,塔利细粉,埃利奥特粉质壤土, d以不同的固体浓度使用高岭土浆料。通过施加每分钟300转(rpm)和1800 rpm之间的离心速度,使浆料承受0.1至40 kPa的外部应力。离心试验和PFT均使用未调节的和阳离子聚丙烯酰胺调节的浆液进行。就保留的沉积物最终固体含量和体积变化而言,将离心机测试结果与PFT结果进行了比较。测试结果表明,饱和条件下保留的沉积物的最大固体浓度对于每种土壤都是唯一的,并且与初始浆料固体浓度无关。测试结果还表明,在任何外部施加的应力下,浆料的初始浓度和最终体积变化之间存在线性关系。最后,提出了土工布管中泵送的总浆料量与脱水沉积物的最终高度之间的关系。 (C)2017 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号