...
首页> 外文期刊>Journal of cardiovascular magnetic resonance : >Three dimensional three component whole heart cardiovascular magnetic resonance velocity mapping: comparison of flow measurements from 3D and 2D acquisitions
【24h】

Three dimensional three component whole heart cardiovascular magnetic resonance velocity mapping: comparison of flow measurements from 3D and 2D acquisitions

机译:三维三成分全心心血管磁共振速度映射:3D和2D采集流量测量的比较

获取原文
           

摘要

BackgroundTwo-dimensional, unidirectionally encoded, cardiovascular magnetic resonance (CMR) velocity mapping is an established technique for the quantification of blood flow in large vessels. However, it requires an operator to correctly align the planes of acquisition. If all three directional components of velocity are measured for each voxel of a 3D volume through the phases of the cardiac cycle, blood flow through any chosen plane can potentially be calculated retrospectively. The initial acquisition is then more time consuming but relatively operator independent.AimsTo compare the curves and volumes of flow derived from conventional 2D and comprehensive 3D flow acquisitions in a steady state flow model, and in vivo through planes transecting the ascending aorta and pulmonary trunk in 10 healthy volunteers.MethodsUsing a 1.5 T Phillips Intera CMR system, 3D acquisitions used an anisotropic 3D segmented k-space phase contrast gradient echo sequence with a short EPI readout, with prospective ECG and diaphragm navigator gating. The 2D acquisitions used segmented k-space phase contrast with prospective ECG and diaphragm navigator gating. Quantitative flow analyses were performed retrospectively with dedicated software for both the in vivo and in vitro acquisitions.ResultsAnalysis of in vitro data found the 3D technique to have overestimated the continuous flow rate by approximately 5% across the entire applied flow range. In vivo, the 2D and the 3D techniques yielded similar volumetric flow curves and measurements. Aortic flow: (mean ± SD), 2D = 89.5 ± 13.5 ml & 3D = 92.7 ± 17.5 ml. Pulmonary flow: 2D = 98.8 ± 18.4 ml & 3D = 94.9 ± 19.0 ml). Each in vivo 3D acquisition took about 8 minutes or more.ConclusionFlow measurements derived from the 3D and 2D acquisitions were comparable. Although time consuming, comprehensive 3D velocity acquisition could be relatively operator independent, and could potentially yield information on flow through several retrospectively chosen planes, for example in patients with congenital or valvular heart disease.
机译:背景技术二维单向编码的心血管磁共振(CMR)速度映射是一种用于量化大血管中血流的成熟技术。但是,这要求操作员正确对准采集平面。如果在心动周期的各个阶段对3D体积的每个体素测量速度的所有三个方向分量,则可以潜在地追溯计算通过任何选定平面的血流量。目的是比较稳态流动模型中常规2D和综合3D流量获取的流量曲线和流量,以及通过横切升主动脉和肺干的平面体内进行的流量比较。 10名健康志愿者。方法使用1.5 T Phillips Intera CMR系统,使用各向异性的3D分段k空间相衬梯度回波序列和短EPI读数进行3D采集,并采用预期的ECG和隔膜导航仪选通。 2D采集使用分段的k空间相位对比以及预期的ECG和隔膜导航器选通。使用专门的软件对体内和体外采集进行了定量流量分析,结果进行了体外数据分析,发现3D技术已将整个应用流量范围内的连续流量高估了大约5%。在体内,2D和3D技术产生了相似的体积流量曲线和测量结果。主动脉流量:(平均±SD),2D = 89.5±13.5 ml和3D = 92.7±17.5 ml。肺流量:2D = 98.8±18.4 ml&3D = 94.9±19.0 ml)。每个体内3D采集大约需要8分钟或更长时间。结论从3D和2D采集获得的流量测量结果是可比的。尽管费时,但是全面的3D速度采集可能相对独立于操作员,并且可能会产生流经多个回顾性选择平面的信息,例如在先天性或瓣膜性心脏病患者中。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号