...
首页> 外文期刊>Advances in Environmental Technology >Preparation of Kissiris/TiO2/Fe3O4/GOx Biocatalyst: Feasibility study of MG decolorization
【24h】

Preparation of Kissiris/TiO2/Fe3O4/GOx Biocatalyst: Feasibility study of MG decolorization

机译:Kissiris / TiO2 / Fe3O4 / GOx生物催化剂的制备:MG脱色的可行性研究

获取原文
   

获取外文期刊封面封底 >>

       

摘要

Titanium dioxide (TiO2) and Fe3O4 magnetite particles were coated on spherical Kissirises; glucose oxidase (GOx) enzyme was immobilized on Kissiris/Fe3O4/TiO2 by physical adsorption. This catalyst was analyzed by a scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTIR), and energy dispersive X-ray (EDX) measurements. The performance of the prepared biocatalyst in the decolorization of Malachite Green dye was investigated. The optimal operation parameters were 20 mg/L, 20 mM, 5.5 and 40 ?C for initial dye concentration, initial glucose concentration, pH and temperature, respectively. Under these conditions, a 95% Malachite Green decolorization efficiency was obtained after 150 min of reaction by using 1 g of prepared heterogeneous bio-Fenton catalyst. In this process, in contrast to a conventional Fenton’s reaction, external hydrogen peroxide and ferrous ion sources were not used. The effect of various reaction parameters such as initial concentration of dye, amount of catalyst, concentration of glucose, pH value and temperature on MG decolorization efficiency was studied.
机译:二氧化钛(TiO2)和Fe3O4磁铁矿颗粒被涂覆在球形Kissirises上。通过物理吸附将葡萄糖氧化酶(GOx)酶固定在Kissiris / Fe3O4 / TiO2上。通过扫描电子显微镜(SEM),傅立叶变换红外光谱(FTIR)和能量色散X射线(EDX)测量来分析该催化剂。研究了制备的生物催化剂对孔雀石绿染料的脱色性能。对于初始染料浓度,初始葡萄糖浓度,pH和温度,最佳操作参数分别为20 mg / L,20 mM,5.5和40°C。在这些条件下,使用1 g制备的非均相生物芬顿催化剂,反应150分钟后,孔雀石绿的脱色效率达到95%。在此过程中,与常规的Fenton反应相反,没有使用外部过氧化氢和亚铁离子源。研究了各种反应参数,例如染料的初始浓度,催化剂的量,葡萄糖的浓度,pH值和温度对MG脱色效率的影响。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号