Assessing axial load transfer mechanism of open-ended tubular piles penetrating in weak rocks using three-dimensional discrete element method

摘要

In order to obtain a better understanding of the load transfer mechanism of open-ended tubular piles driven into weak rocks, numerical analysis is conducted to study the internal and external shaft frictions, base resistance and the stress distribution pattern in the surrounding rock mass. Meanwhile, since pile shoes are often applied when driving to the rock layer, a common inner pile shoe attached to the open-ended tubular pile was analysis and compared with the pile without a shoe. In this study, the discrete element method (DEM), which can mimic rock grains and the interaction between grains, is adopted due to its ability to simulate large deformation problems such as pile penetration process. The flat-joint model that allows partial damage at the contact interface was employed to replicate the discrete nature of the rock mass. The rock behaviour was calibrated against triaxial test results for a pyroclastic weak rock, and then the calibrated rock was employed for the simulation of pile penetration. A 30 degrees segment of the true-scale model was simulated using the DEM with a height of 3 m and a radius of 1.5 m, which was composed of about 557,000 particles. Initial stresses were applied at the boundary of the testing chamber, while the side of the chamber was discretised into several sections with increasing horizontal stresses with depth to establish the at rest condition. Numerical results for penetration of an open-ended tubular pile show that the external shaft resistance of the pile with inner pile shoe increased approximately linearly as the pile penetrated deeper. In addition, the internal shaft friction was notably less than the external shaft friction for both piles with and without a shoe. Plugging was observed for both piles with and without a driving shoe. The inner pile shoe allowed the pile partial plugging to occur at shallower penetration depth. This study sheds a light on the load transfer mechanism of the open-ended tubular piles and the effect of the shoe on the axial capacity of the piles in weak rocks.