...
首页> 外文期刊>IEEE Transactions on Biomedical Engineering >Reduced-Order Preconditioning for Bidomain Simulations
【24h】

Reduced-Order Preconditioning for Bidomain Simulations

机译:双域仿真的降阶预处理

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Simulations of the bidomain equations involve solving large, sparse, linear systems of the form Ax=b. Being an initial value problems, it is solved at every time step. Therefore, efficient solvers are essential to keep simulations tractable. Iterative solvers, especially the preconditioned conjugate gradient (PCG) method, are attractive since memory demands are minimized compared to direct methods, albeit at the cost of solution speed. However, a proper preconditioner can drastically speed up the solution process by reducing the number of iterations. In this paper, a novel preconditioner for the PCG method based on system order reduction using the Arnoldi method (A-PCG) is proposed. Large order systems, generated during cardiac bidomain simulations employing a finite element method formulation, are solved with the A-PCG method. Its performance is compared with incomplete LU (ILU) preconditioning. Results indicate that the A-PCG estimates an approximate solution considerably faster than the ILU, often within a single iteration. To reduce the computational demands in terms of memory and run time, the use of a cascaded preconditioner was suggested. The A-PCG was applied to quickly obtain an approximate solution, and subsequently a cheap iterative method such as successive overrelaxation (SOR) is applied to further refine the solution to arrive at a desired accuracy. The memory requirements are less than those of direct LU but more than ILU method. The proposed scheme is shown to yield significant speedups when solving time evolving systems
机译:双域方程的仿真涉及求解形式为Ax = b的大型稀疏线性系统。作为初始值问题,它在每个时间步都得到解决。因此,有效的求解器对于使仿真易于处理至关重要。迭代求解器,尤其是预处理共轭梯度法(PCG),很有吸引力,因为与直接方法相比,内存需求最小化,尽管以求解速度为代价。但是,适当的预处理器可以通过减少迭代次数来大大加快求解过程。本文提出了一种新的PCG方法预处理器,它基于使用Arnoldi方法(A-PCG)的系统阶数约简。使用A-PCG方法解决了在采用有限元方法公式进行的心脏双畴模拟过程中生成的大阶系统。将其性能与不完全LU(ILU)预处理进行比较。结果表明,A-PCG估计近似解决方案的速度比ILU快得多,通常在一次迭代中。为了减少内存和运行时间方面的计算需求,建议使用级联的预处理器。应用A-PCG来快速获得近似解,然后应用便宜的迭代方法(例如连续超松弛(SOR))来进一步优化解,以达到所需的精度。内存需求比直接LU少,但比ILU方法大。当解决时间演化系统时,建议的方案显示出明显的加速效果

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号