首页> 外文期刊>Atmospheric environment >Factors affecting non-tailpipe aerosol particle emissions from paved roads: On-road measurements in Stockholm, Sweden
【24h】

Factors affecting non-tailpipe aerosol particle emissions from paved roads: On-road measurements in Stockholm, Sweden

机译:影响铺装道路非尾气溶胶颗粒排放的因素:瑞典斯德哥尔摩的道路测量

获取原文
获取原文并翻译 | 示例
           

摘要

A large fraction of urban PM_(10) concentrations is due to non-exhaust traffic emissions. In this paper, a mobile measurement system has been used to quantify the relative importance of road particle emission and suspension of accumulated dust versus direct pavement wear, tire type (studded, friction, and summer), pavement type, and vehicle speed. Measurements were performed during May-September on selected roads with different pavements and traffic conditions in the Stockholm region. The highest particle mass concentrations were always observed behind the studded tire and the lowest were behind the summer tire; studded-to-summer ratios were 4.4-17.3 and studded-to-friction ratios were 2.0—6.4. This indicates that studded tires lead to higher emissions than friction and summer tires regardless to the asphalt type. By comparing with measurements in a road simulator, it could be estimated that the pavement wear due to the friction tires was 0.018-0.068 of the suspension of accumulated road dust. Likewise for studded tires road-wear was estimated to be 1.2-4.8 the suspension of accumulated dust. This indicates that wear due to friction tires is very small compared to the suspension of accumulated dust and that suspension due to studded tires may sometimes be as large as the wear of the road. But this will vary depending on, e.g. the amount of dust accumulated on the roads. An important dependence on vehicle speed was also observed. During May, the particle mass concentrations behind the studded tire at vehicle speed 100km h~(-1) were about 10 times higher than that at 20 km h~(-1). The speed dependence was not so pronounced in September, which could be due to less accumulated dust on the roads. The particle number size distribution of the emissions due to road wear by studded tire was characterized by a clear increase in number concentrations of the coarse fraction of aerosol particles, with a geometric mean diameter between 3 and 5 μm. The size distribution of the emissions due to the summer tire was very similar with smaller concentrations. An important limitation with the measurements presented is that they were made by using a van, which is bigger than regular cars and has bigger tires. Thus, road wear and dust suspension due to cars are expected to be different.
机译:城市PM_(10)浓度的很大一部分归因于非排放交通排放。在本文中,移动测量系统已被用于量化道路颗粒物排放和悬浮尘埃相对于直接路面磨损,轮胎类型(镶钉,摩擦和夏季),路面类型和车速的相对重要性。在5月至9月期间,对斯德哥尔摩地区具有不同人行道和交通状况的部分公路进行了测量。始终在镶钉轮胎后方观察到最高的颗粒质量浓度,而在夏季轮胎后方观察到最低的颗粒质量浓度;钉对夏天的比率是4.4-17.3,钉对摩擦的比率是2.0-6.4。这表明无论沥青类型如何,带钉轮胎导致的排放量均高于摩擦轮胎和夏季轮胎。通过与道路模拟器中的测量值进行比较,可以估计出由于摩擦轮胎引起的路面磨损为所积聚的道路扬尘的0.018-0.068。同样,对于带钉轮胎,道路磨损的悬浮物估计为1.2-4.8。这表明与堆积的灰尘的悬浮相比,摩擦轮胎引起的磨损非常小,而双头钉轮胎引起的悬浮有时可能与路面的磨损一样大。但这取决于例如道路上积聚的灰尘量。还观察到对车速的重要依赖。 5月,车速为100 km h〜(-1)时,涂钉轮胎后方的颗粒质量浓度比20 km h〜(-1)时高10倍。 9月份对速度的依赖性不太明显,这可能是由于道路上积聚的灰尘较少所致。钉书钉轮胎由于道路磨损而产生的排放物的颗粒大小分布特征是,粗颗粒气溶胶颗粒的浓度明显增加,其几何平均直径为3至5μm。夏季轮胎产生的排放物的尺寸分布与浓度较小的情况非常相似。呈现的测量值的一个重要限制是它们是使用货车制造的,该货车比普通汽车更大,轮胎更大。因此,预计由于汽车引起的道路磨损和灰尘悬浮将有所不同。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号