首页> 外文期刊>IEEE Transactions on Applied Superconductivity >A K-band (HTS,gold)/ferroelectric thin film/dielectric diplexer for a discriminator-locked tunable oscillator
【24h】

A K-band (HTS,gold)/ferroelectric thin film/dielectric diplexer for a discriminator-locked tunable oscillator

机译:用于鉴频器锁定可调振荡器的K波段(HTS,金)/铁电薄膜/电介质双工器

获取原文
获取原文并翻译 | 示例
           

摘要

The performance of a K-band conductor/ferroelectric thin film/dielectric tunable diplexer that is being developed as a critical part of a discriminator-locked tunable oscillator will be discussed. This diplexer consists of two K-band (18 to 22 GHz), two-pole YBCO/SrTiO/sub 3//LaAlO/sub 3/ bandpass filters coupled to the microwave signal input port through a 50 /spl Omega/ power splitter. When tested independently at 77 K and varying bias of /spl plusmn/400 V, these filters exhibited a passband frequency shift greater than 1.7 GHz, while maintaining a non-deembedded insertion loss near 2.0 dB. Electromagnetic modeling results for the diplexer indicate that varying the dielectric constant of the SrTiO/sub 3/ from 3000 (/spl sim/77 K) to 500 (/spl sim/300 K) will shift the diplexer's "cross-over" frequency from 19 to 21 GHz, with only minor variations in insertion loss. Measurements at 298 K of this diplexer circuit using a gold/SrTiO/sub 3// LaAlO/sub 3/ structure resulted in non-deembedded insertion losses of 3.3 dB and 2.5 dB at the filters' maxima at 20.65 and 22.43 GHz, respectively, with a cross-over frequency at 21.07 GHz. These room temperature results are consistent with modeling. The measured characteristics of YBCO/SrTiO/sub 3//LaAlO/sub 3/ diplexers at cryogenic temperatures will be presented.
机译:将讨论被开发为鉴频器锁定的可调振荡器的关键部分的K波段导体/铁电薄膜/电介质可调双工器的性能。该双工器包括两个K波段(18至22 GHz),两极YBCO / SrTiO / sub 3 // LaAlO / sub 3 /带通滤波器,它们通过50 / spl Omega /功率分配器耦合到微波信号输入端口。当在77 K和/ spl plusmn / 400 V的变化偏压下独立测试时,这些滤波器表现出的通带频移大于1.7 GHz,同时未嵌入的插入损耗保持在2.0 dB附近。双工器的电磁建模结果表明,将SrTiO / sub 3 /的介电常数从3000(/ spl sim / 77 K)更改为500(/ spl sim / 300 K)将使双工器的“交叉”频率从19至21 GHz,插入损耗只有很小的变化。使用金/ SrTiO / sub 3 // LaAlO / sub 3 /结构在该双工器电路的298 K下进行的测量分别导致在20.65 GHz和22.43 GHz的滤波器最大值处的非去嵌入插入损耗分别为3.3 dB和2.5 dB,交叉频率为21.07 GHz。这些室温结果与建模一致。将介绍在低温下YBCO / SrTiO / sub 3 // LaAlO / sub 3 /双工器的测量特性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号