...
首页> 外文期刊>Advanced Functional Materials >Transparent Ultrathin Oxygen-Doped Silver Electrodes for Flexible Organic Solar Cells
【24h】

Transparent Ultrathin Oxygen-Doped Silver Electrodes for Flexible Organic Solar Cells

机译:透明的超薄氧掺杂银电极,用于柔性有机太阳能电池

获取原文
获取原文并翻译 | 示例

摘要

An effective method for depositing highly transparent and conductive ultrathin silver (Ag) electrodes using minimal oxidation is reported. The minimal oxidation of Ag layers significantly improves the intrinsic optical and structural properties of Ag without any degradation of its electrical conductivity. Oxygen-doped Ag (AgO_x) layers of thicknesses as low as 6 nm exhibit completely 2D and continuous morphologies on ZnO films, smaller optical reflections and absorbances, and smaller sheet resistances compared with those of discontinuous and granular-type Ag layers of the same thickness. A ZnO/AgO_x/ZnO (ZAOZ) electrode using an AgO_x (O/Ag = 3.4 at%) layer deposited on polyethylene terephthalate substrates at room temperature shows an average transmittance of 91%, with a maximum transmittance of 95%, over spectral range 400-1000 nm and a sheet resistance of 20 Q sq~(-1). The average transmittance value is increased by about 18% on replacing a conventional ZnO/Ag/ZnO (ZAZ) electrode with the ZAOZ electrode. The ZAOZ electrode is a promising bottom transparent conducting electrode for highly flexible inverted organic solar cells (lOSCs), and it achieves a power conversion efficiency (PCE) of 6.34%, whereas an IOSC using the ZAZ electrode exhibits a much lower PCE of 5.65%.
机译:报道了一种使用最少的氧化来沉积高度透明且导电的超薄银(Ag)电极的有效方法。 Ag层的极少氧化可显着改善Ag的固有光学和结构性质,而不会降低其电导率。与相同厚度的不连续和粒状Ag层相比,厚度低至6 nm的氧掺杂Ag(AgO_x)层在ZnO膜上具有完全二维和连续形貌,较小的光反射和吸收率以及较小的薄层电阻。在室温下使用沉积在聚对苯二甲酸乙二醇酯基板上的AgO_x(O / Ag = 3.4 at%)层的ZnO / AgO_x / ZnO(ZAOZ)电极在光谱范围内的平均透射率为91%,最大透射率为95% 400-1000 nm,薄层电阻为20 Q sq〜(-1)。用ZAOZ电极代替常规ZnO / Ag / ZnO(ZAZ)电极后,平均透射率值增加了约18%。 ZAOZ电极是用于高柔性反向有机太阳能电池(lOSC)的有希望的底部透明导电电极,它的功率转换效率(PCE)为6.34%,而使用ZAZ电极的IOSC的PCE则低得多,为5.65% 。

著录项

  • 来源
    《Advanced Functional Materials》 |2014年第11期|1551-1561|共11页
  • 作者单位

    Surface Technology Division,Korea Institute of Materials Science,Changwon, Gyeongnam, 641-831, Republic of Korea,Key Laboratory for Liquid-Solid Structural Evolution and Processing of Materials Shandong University Jinan, 250061, China;

    Surface Technology Division,Korea Institute of Materials Science,Changwon, Gyeongnam, 641-831, Republic of Korea;

    Jeonju Center Korea Basic Science Institute Jeonju, Jeonbuk, 561-180, Republic of Korea;

    Surface Technology Division,Korea Institute of Materials Science,Changwon, Gyeongnam, 641-831, Republic of Korea;

    Department of Chemistry Pukyong National Univeristy Busan, 608-737, Republic of Korea;

    Daegu Center Korea Basic Science Institute Daegu, 702-701, Republic of Korea;

    IT&.E Materials Division LG Chem. Research Park Daejeon, 305-380, Republic of Korea;

    Surface Technology Division,Korea Institute of Materials Science,Changwon, Gyeongnam, 641-831, Republic of Korea;

    Surface Technology Division,Korea Institute of Materials Science,Changwon, Gyeongnam, 641-831, Republic of Korea;

    Key Laboratory for Liquid-Solid Structural Evolution and Processing of Materials Shandong University Jinan, 250061, China;

    Surface Technology Division,Korea Institute of Materials Science,Changwon, Gyeongnam, 641-831, Republic of Korea;

    Professional Graduate School of Flexible and Printable Electronics Department of Flexible and Printable Electronics Chonbuk National University Jeonju, 561-756, Republic of Korea;

    Surface Technology Division,Korea Institute of Materials Science,Changwon, Gyeongnam, 641-831, Republic of Korea;

  • 收录信息
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号