首页> 美国卫生研究院文献>Nanoscale Research Letters >Aluminum silicide microparticles transformed from aluminum thin films by hypoeutectic interdiffusion
【2h】

Aluminum silicide microparticles transformed from aluminum thin films by hypoeutectic interdiffusion

机译:亚共晶互扩散从铝薄膜转化硅化铝微粒

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

Aluminum silicide microparticles with oxidized rough surfaces were formed on Si substrates through a spontaneous granulation process of Al films. This microparticle formation was caused by interdiffusion of Al and Si atoms at hypoeutectic temperatures of Al-Si systems, which was driven by compressive stress stored in Al films. The size, density, and the composition of the microparticles could be controlled by adjusting the annealing temperature, time, and the film thickness. High-density microparticles of a size around 10 μm and with an atomic ratio of Si/Al of approximately 0.8 were obtained when a 90-nm-thick Al film on Si substrate was annealed for 9 h at 550°C. The microparticle formation resulted in a rapid increase of the sheet resistance, which is a consequence of substantial consumption of Al film. This simple route to size- and composition-controllable microparticle formation may lay a foundation stone for the thermoelectric study on Al-Si alloy-based heterogeneous systems.
机译:通过铝膜的自发造粒过程,在硅衬底上形成了具有氧化粗糙表面的硅化铝微粒。这种微粒的形成是由于Al-Si系统在低共晶温度下Al和Si原子的相互扩散引起的,这是由Al膜中存储的压缩应力驱动的。可以通过调节退火温度,时间和膜厚度来控制微粒的尺寸,密度和组成。当在550°C下将9纳米厚的Si衬底上的Al膜退火9小时时,可获得尺寸约为10μm且Si / Al原子比约为0.8的高密度微粒。微粒的形成导致薄层电阻的快速增加,这是铝膜大量消耗的结果。这种形成尺寸和组成可控的微粒的简单方法,可以为基于Al-Si合金的异质系统进行热电研究奠定基础。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号