首页> 美国卫生研究院文献>Journal of Applied Clinical Medical Physics >Validation of a GPU‐Based 3D dose calculator for modulated beams
【2h】

Validation of a GPU‐Based 3D dose calculator for modulated beams

机译:验证用于调制光束的基于GPU的3D剂量计算器

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

A superposition/convolution GPU‐accelerated dose computation algorithm (the Calculator) has been recently incorporated into commercial software. The algorithm requires validation prior to clinical use. Three photon energies were examined: conventional 6 MV and 15 MV, and 10 MV flattening filter free (10 MVFFF). For a set of IMRT and VMAT plans based on four of the five AAPM Practice Guideline 5a downloadable datasets, ion chamber (IC) measurements were performed on the water‐equivalent phantoms. The average difference between the Calculator and IC was −0.3 ± 0.8% (1SD). The same plans were projected on a phantom containing a biplanar diode array. We used the forthcoming criteria for routine gamma analysis, 3% dose>–error (global (G) normalization, 2 mm distance to agreement, and 10% low dose cutoff). The γ (3%G/2 mm) average passing rate was 98.9 ± 2.1%. Measurement‐guided three‐dimensional dose reconstruction on the patient CT dataset (excluding the Lung) resulted in a similar average agreement rate with the Calculator: 98.2 ± 2.0%. The mean γ (3%G/2 mm) passing rate comparing the Calculator to the TPS (again excluding the Lung) was 99.0 ± 1.0%. Because of the significant inhomogeneity, the Lung case was investigated separately. The calculator has an alternate heterogeneity correction mode that can change the results in the thorax for higher‐energy beams (15 MV). As this correction is nonphysical and was optimized for simple slab geometries, its application leads to mixed results when compared to the TPS and independent Monte Carlo calculations, depending on the CT dataset and the plan. The Calculator vs. style="fixed-case">TPS 15 style="fixed-case">MV Guideline 5a style="fixed-case">IMRT and style="fixed-case">VMAT plans demonstrate 96.3% and 93.4% γ (3%G/2 mm) passing rates respectively. For the lower energies, which should be predominantly used in the thoracic region, the passing rates for the same plans and criteria range from 98.6 to 100%. Overall, the Calculator accuracy is sufficient for the intended use.
机译:叠加/卷积GPU加速剂量计算算法(计算器)最近已集成到商业软件中。该算法需要在临床使用之前进行验证。检查了三个光子能量:常规的6 MV和15 MV,以及没有10 MV平坦滤波器的(10 MVFFF)。对于基于五份AAPM实践指南5a可下载数据集中的四个的一组IMRT和VMAT计划,对水等效模型进行了离子室(IC)测量。计算器和IC之间的平均差为-0.3±0.8%(1SD)。将相同的计划投影到包含双平面二极管阵列的模型上。我们使用即将出现的标准进行常规的伽玛分析,3%剂量> – 误差(全局(G)归一化,2 mm的一致距离和10%的低剂量截止)。 γ(3%G / 2 mm)的平均合格率为98.9±2.1%。在患者CT数据集(不包括肺)上进行以测量为导向的三维剂量重建,得出与计算器相似的平均同意率:98.2±2.0%。将计算器与TPS(同样不包括肺脏)进行比较的平均γ(3%G / 2 mm)通过率为99.0±1.0%。由于存在明显的不均匀性,因此对肺病例进行了单独调查。计算器具有另一种异质性校正模式,可以更改高能光束(15 MV)胸腔中的结果。由于这种校正是非物理性的,并且针对简单的板坯几何形状进行了优化,因此,与TPS和独立的Monte Carlo计算(取决于CT数据集和计划)相比,其应用会导致混合结果。计算器与 style =“ fixed-case”> TPS 15 style =“ fixed-case”> MV 准则5a style =“ fixed-case”> IMRT 和 style =“ fixed-case”> VMAT 计划分别显示出96.3%和93.4%的γ(3%G / 2 mm)通过率。对于较低的能量(应主要在胸腔区域使用),相同计划和标准的通过率在98.6至100%之间。总体而言,计算器的精度足以满足预期用途。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号