【2h】

Thickness of Adsorbed Polystyrene Layers by Ellipsometry

机译:椭偏法测量的聚苯乙烯层的厚度

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

The adsorption of polystyrene from cyclohexane below the theta temperature onto chrome ferrotype plate was studied by means of ellipsometry (polarization spectrometry). In this technique changes in the state of polarization of polarized light are measured upon reflection from a film-covered surface. The measurements were carried out in situ and permitted determination of the thickness and refractive index of the swollen polymer film at the solidsolution interface. A concentration range of 0.18 to 9.7 mg/ml was studied for polymer with a molecular weight of 76,000. The thickness of the adsorbed film increased with increasing solution concentration, reaching a plateau for most of the concentration range studied. The average thickness at this plateau was approximately 210 Å. The adsorbed film was highly swollen, consisting of about 12 g/100 ml of polymer for most of the concentration range. The amount adsorbed was determined to be approximately 2.25×10−4 mg/cm2 at the plateau. Comparison of the radius of gyration of polystyrene in solvent is made to the results obtained.
机译:通过椭偏法(极化光谱法)研究了温度低于theta温度的环己烷中聚苯乙烯在铬铁版板上的吸附。在该技术中,在从被覆膜的表面反射时测量偏振光的偏振状态的变化。测量是在原位进行的,并允许确定固溶体界面处溶胀的聚合物膜的厚度和折射率。研究了分子量为76,000的聚合物的浓度范围为0.18至9.7 mg / ml。吸附膜的厚度随溶液浓度的增加而增加,在所研究的大多数浓度范围内均达到平稳状态。在该平台的平均厚度约为210。吸附的膜高度溶胀,在大部分浓度范围内由约12 g / 100 ml的聚合物组成。确定在高原上的吸附量约为2.25×10 -4 mg / cm 2 。比较所得聚苯乙烯在溶剂中的回转半径。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号